Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
I'd like to use the GATT/GAP driver from an ARM based Linux system. Is there any possibility of getting a library compiled for ARM or (cough) the source code to build it myself...
I've previously successfully done interval advertisements using a SoftDevice with Nordic's previous (non-Zephyr) sdk, but I'm having issues replicating it on Zephyr.
Our...
Hi, I am using the nRF52840 with the softdevice s140 6.1.1 with the SDK 15.3 with FreeRTOS. Sometimes after collecting data for a around a day the device sometimes crashes...
Hi,
It has been a while since I looked up on different resources to get SPI slave transaction example and I finally found on the `nrf / samples / tfm / tfm_secure_peripheral...
Hello,
I have three questions regarding FEM.
#1 According to the following URL, FEM function is supported only for nRF52 series.
Would the FEM function be available...
Hi We are working on a new product that includes NFC, When we measure the voltage level we do not reach more than 600mv. The matching was done by capacitors: using a 2uH antenna...
Dear all,
I could happily flash my firmware to my nrf52840 upon pressing reset button. When pressing the reset button the diode on the board started to beat red and via...
Dear Mate,
i need brief explanation about below mcu bootloader like 1. starting bootloader how this starting bootloader works and where from it prints starting bootloader...
I am looking to design a board with two microcontrollers, the nRF52840 will be the primary micro plus another that will be connected via UART.
The second micro can be updated...
Hi Nordic,
I am trying to test PER. I used MODULATED_TX_DUTY_CYCLE(with different duties) and MODULATED_TX types at transmitter. Used the same fireware at receiver.
The...
Hi,
i got a project which i need to know if a person put an object in it's place.
The project got 2 elements:
1) Beacon transmitter (@ 0 dbm) attached to the object...
Hello,
I have my s332 application working properly, I have an Android phone and never got any connection errors. Using nrfConnect app I tried to connect from iOS and an...
Hi everyone,
I'd like to check DEVICES (Light switch server) is still alive in the BLE mesh network through GATEWAY (Serial example) but I don't know how to check it. Can...
I am exploring the nRF52832 using nRF52-DK for a low powered BLE device. And for that I am making the System OFF example as my basis for measuring currents of different features...
