Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi all After successful installation of an update with the hep of dfu_target module, I am expecting the bootloader to swap the image and boot the new image with swap_type...
Hello! I have a nrf52840 DK. I am trying to build a custom keyboard on that SoC. I was able to compile and install nRF Connect SDK example on my DK. Everything works! ZMK...
Hello,
In continuation to the ticket: https://devzone.nordicsemi.com/f/nordic-q-a/70795/replacing-s140-with-s340-softdevice
I'm trying to switch between S140 and S340...
Hi,
I think I found a BUG about SPIM SDK15.3. The following is what I set the configurations for the SPIM0:
Then I use this function to active one transfer which just...
Hi,
I'm using nrf connect SDK 1.7 and following below guidelines to add I2C.
https://devzone.nordicsemi.com/nordic/nrf-connect-sdk-guides/b/peripherals/posts/twi-ic2-implementation...
Hi,
we have few queries regarding lighting mesh models support in ncs1.6.1
we were using NCS1.6.1 for mesh development
we were facing some compilation issues with LC...
I am using nRF52840 Dongle as Sniffer using Dongle. But when it captures the advertising packets,i am not able to see the preamble in the decoded packets. Please help!
Hello Everyone
I am really new to everything here, i just got nRF 9160dk board.
Can anyone please tell me the step-by-step method on how to make a very simple program...
Hello DevZone,
I am planning on making a system that uses peer manager ranking to determine which oldest bond I need to delete to make room for a new one.
I am using...
Hi Team,
we're developing firmware to send long range beacon by using LECODED phy channel. We notice that there is increase in energy consumption during advertising and...
Goal: Using NRF9160DK board, communicate nrf9160 and nrf52840 over UART
I tried to use UARTE on both sides. Below is project configuration and overlay file for both boards...
Hi,
I was using the AWS-IOT example and all was working until it wasnt. In troubleshooting this, I loaded the modem shell example, to see if it was a network/connection...
Hi everyone,
I implemented nrf5_SDK_17.0.2 ble_app_uart example, so I connected an external device to my nRF52840 DK and I received the data by my android phone.
Now I...
