Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
The set up which are used are a nRF52840 dongle programmed through nRF52832DK's debugger. After executing "erase all" in Programmer app, which erased the bootloader, it's...
We are using NRF52832 based Module in our design. Currently BLE Services & characteristics used in our firmware: 1. Custom Service characteristic 1: 37 Bytes characteristic...
Hi,
I understand that BLE Logical Link Control and Adaptation Layer Protocol is responsible for protocol multiplexing capability.
Can you please explain what kind of protocol...
Hey,
when i call:
otLinkSetChannel(OTInstance, ThreadChannelToUse);
from the very beginning of the programm:
void main(void) { int ret; ret = InitLEDs(); InitTemperatureMeasurement...
We are using nrf5340-dk to communicate with nrf5340 custom board and trying to search for the other sensors' addresses. There is secure mode and unsecure mode CPU. Which mode...
Hi.
My first attempt to get SAADC to work was:
NRF_SAADC->INTENSET = (SAADC_INTEN_RESULTDONE_Enabled << SAADC_INTEN_RESULTDONE_Pos) | //A result is ready to get transferred...
Hi,
Can I connect a 3.7V Li ion battery to the dongle VBUS keeping the SB1 and SB2 configurations as default?
Would this 3.7V applied to IC's VBUS pin cause any issue...
I want to view extended advertising, auxiliary advertising , LE coded data.
i had installed nrf sniffer app wireshark but it doesnt display this.
Ellysis bluetooth tracker...
Hello,
I am working on NRF52805.
I am able to debug my program with J-link using SEGGER.
However, when I try to download the program it seems like it is not running...
Hello. I am developing using nrf52832 (S132 v7.0.1, SDK v16.0.0) as central.
Is it possible to change the Tx Power while connected to the device? I made it possible to change...
Hi,
I am migrating my project from SDK15 to SDK 17.0.2. I am using NRF52840 development kit and using s140 softdevice for bluetooth services. When I load the softdevice...
Hello.
I'm trying to make very simple iBeacon. So, I modified an example of 'ble_app_beacon'.
Things what I have done are below
1. wrote J-Link OB-SAM3U128-V2-NordicSemi...
