I'm trying to solve an intermittent problem when using the nRF51422 UART with CMSIS-RTOS (RTX) and MDK Networking library (V6.2) (TCP/IP stack).
My questions relate to...
Hi...
When i was working in SDK v6.1.0 i have tried nrfprog.exe to merge and program bootloader, softdevice, application and bootloader_settings file as explained in devzone...
But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hello everyone!
I've been struggling to get over this error when attempting to use an augmented Thread project based on the thread_mqtt_sn_client_publisher example. Would...
According the nordic documentation of the AT command +CEINFO, the value of CINR is in dBm.
Other source (outside Nordic) mention dB as common unit, e.g. LTE signal quality...
Hello everyone,
I'm trying to display internal sensor on NRF51422-DK (PCA10028) on my Android phone (v.12). I'm using Keil for programming and nRF Toolbox to see UART results...
ble_gap_addr_t xyz;
sd_ble_gap_addr_get(&xyz);
/**@brief Get local Bluetooth identity address. * * @note This will always return the identity address irrespective of the...
Hello, I have three questions that i could not clarify in an adequate amount of time via Google and DevZone.
Setup: I am working on a custom board equipped with nRF52805...
Good day
I am trying to use lwm2m_engine_set_float on the lwm2m_client sample to change the sensor value.
Referring to the above link, the sensor value is set in the...
I am trying to evaluate transitioning a product from the NRF52840 to the NRF5340, but we have a critical feature that uses specific functionality of the PPI. It seems that...
Trying to integrate memfault SDK to nRF SDK 17 segger embedded studio. But couldn't understand the below section. Can someone help with passing flags to linker and also adding...
hi,i use SDK17.02.
l use ESB RX mode, I need send the ack payload data, and I can only write it for 8 times. After I write it for 8 times, I use nrf_esb_flush_tx() to clear...
I am building a Thread Coprocess using the nRF Thread Coprocessor template . Everything seems to work fine except when I use the OPENTHREAD_MANUAL_START=n config in the prj...
hi dev.
I study ble uart.
and I succeed connecting with dk board(peripheral) and nrf tool box(uart).
and I also connected with dk board and putty. // like that computer...
Hello Community,
I am trying to test mqtt_simple sample on both of nRF9160-DK(nRF9160 SICA B1) and Thingy91(nRF9160 SICA B0). My hardware version: nRF9160-DK: 1.0.0 Thingy91...
Hi!
Is it possible to configure a the nRF52833 to a fixed radio channel, on which BLE signals are received (Only RX-mode)?
Thank you very much for answering my question...
We have a keyboard, and user can switch to different central device.
In old nrf sdk, we use different mac address map to different cantral when bonded.
But in ncs 2.0...
