Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hi,
Currently, I am using the nrf52840 (ISP1807) for my device, I am presently flashing it with my pc with nrf connect program and taking the necessary pin out from the...
Hello,
Based on the nrf_cloud_mqtt_multi_service sample I am trying to create a MQTT connection to the nRF cloud.
I am able to successful create a connection, but after...
Hi,
I want to use Bluetooth LE in a project for nRF9160DK. My understanding is that the main program should run on the SiP nRF9160 and it will be the nRF5280 that will perform...
Where can I find a specification with time for advertising device waits after sent adv packet for connection from central to it?
What time I have for handle some logic on...
Hi,
I'm using nRF52840 dongle and nRF connect SDK 1.6.0 (Zephyr) to create a BLE HID + USB CDC device. Is it possible to jump to bootloader from application code (or ideally...
We followed the below with Apple phone iOS 16.1.2 for provisioning.
developer.nordicsemi.com/.../sample_description.html
We completed provisioning the device.
But we...
Hello,
I have a custom prototype board using the nRF9160 that will gather GPS position information as a feature. The (previous)first PCB (of the exact same board) that I...
Hi,
ncs v2.2.0 sample, central_nfc_pairing, use NFC reader to pair.
If I want to use another mcu as host with NFC reader, and communicate nRF5340 through UART.
Which...
Is there a guide to adding a peripheral device using the PinCtrl module?
I am looking for something like
But using the newer module included in ncs v2.x.x.
Hi,
I am having trouble getting the build to complete for the Audio DK demo ( https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/applications/nrf5340_audio...
Hey!
Is it possible to flash/program the NRF5340 over USB data lines? I've integrated a 2 wire SWD interface, but it would be incredible if I could remove it and just use...
Hello All.
I am new to BLE mesh development as well as the Zephyr RTOS. We are testing BLE mesh sensor network and we require AES encryption as the hardware supports it...
Hi,
I'm implementing usb communication using nRF52840-CIAA.
I used usbd(peripheral) example of sdk 17.1.0.
This is my board circuit.
- DVDD_MDBT42P : 3.3V from LDO...
Hello
I am a product development team leader and mobile (iOS, Android) app developer.
Our product uses NUS to control the product.
Currently, encryption is not applied...
