But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
nRF52840, nRF Connect
I was looking at the button example and it is apparently a little different then in the nRF5 SDK kit. In the SDK you had a callback and inside that...
Hi!
For a custom project, I need to enable and disable soft device on a peripheral. I'm able to enable/disable softdevice for two cycles, then I get this error:
<error...
Hi,
I'm trying to mount two spi flash device on spi0, but can't found the second one(device_get_binding() return NULL).
The two device has compatible ("jedec,spi-nor"...
Hello Support,
In my project I use the nrf52840 with the nRF Connect SDK to create a OpenThread device with an Secure MQTT connection to a broker.
I've got the OpenThread...
Hi. I am trying to output a square wave on to separate output pins. I want to have one inverted, however I can't even get the same output on both pins at the moment. The pin...
I want to use HCI_USB on nRF52840 board(nrf connect SDK).
Legacy Advertising Scan is success.
But,, I don't know how to recieve the Extended Advertising Scan.
Please...
We have an nRF52840 operating as BLE peripheral that ix using sd_ble_gatts_hvx() to notify an attribute value. Because we are using an RTOS, after calling sd_ble_gatts_hvx...
Good morning,
DK: nrf5340 Audio DK
SDK : V2.0.0
Toolchain Manager: V1.1.3
nRF Connect for Desktop: v3.11.1
I am trying to work with nrf5340 Audio DK. I was able...
Hi,
I was working with my Thingy:91 all worked fine. Wanted to upgrade to latest firmware and somehow in this process the USB interface stopped working. I switched to use...
hi,
i am using sdk_17.0.2 and nrf52840.
I want to get 6 pwm outputs like in the picture.
They all have to start at the same time.
20 khz signals should be.
i...
