But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
My set up contains beagle bone black as Application board. PCA10001 board with S120 Softdevice using nordic_sdk_10 running ble_connectivity example program.
I initiated...
I have a Teledyne protocol analyzer for capturing over the air data between an nRF52840-DK and an iPhone 8 device. How do I obtain the encryption key from the nRF52840 SoC...
Hi,
I want to verify Bluetooth on my board is good or bad.
Note that, I do not have any spectrum analyzer or vector network analyzer, just development kit.
I found example...
On the product page the nRF52810 is mentioned as supporting ANT. https://www.nordicsemi.com/eng/Products/nRF52810
However in the info-center looking at the compatibility...
Apologies if this is a Segger question vs a Nordic question.
I have already been evaluating SES for a non-Nordic project, and so it's already installed [on Mac].
I am...
Hello Nordic,
I have already used an earlier version of nrfconnect on this lcomputer( windows 10 language PT-BR).
After upgrading to 2.6.1 I got the the error below: ...
Zboss som times gets stuck in loop trying to start network steering when running sample, most of the time it eventually makes it out of the loop
but what causes the failure...
Hi,
I am using nrf51822 to get DS18B20's temperature data, but I am fail to do it.
Would you please give me an sample C source code which can get temperature data from...
in nRF5_SDK_14.2.0_17b948a project, we get sensor x y z w data in a loop process, the data which print in uart shows very smoothly.
but if i push buttons many times in a...
https://github.com/NordicPlayground/nrf52-ble-multi-link-multi-role
I use this code.
The connection to thingy was successful. max connection is 10.
The discovery of...
Hello,
are there any new information about the provisioning application? I´d like to set up a Bluetooth Mesh with nrf52840PDK boards and use my smartphone as a provisioner...
Hello Everyone: I have a question: our device needs the long range function, but at the same time, it also needs to wait for the phone to connect. The device and device can...
I am using nRF 5 SDK v 14.2.0.
Store six items of data in flash memory with int or float,
In the program, the values of the six items are acquired,
I want to operate with...
Hello everyone,
I started porting our software from NRF52830 to NRF840.
I am currently stuck with a weird problem: I a unable to use and configure PINs of the NRF52840...
