After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
The issue is as stated in the title. The 'Select Device' column says "Connect a Nordic development kit to your computer" when the Power Profiler is NOT plugged in. This imediately...
Can someone help me with a Zephyr compiled blinky hex file please?
My Hardware is a loose standing module setup similar to NRF52833 DK. (same led_0)
NRF5 Sdk hex file...
I am using fstorage to store some data at three location in flash.
but it is hanging at wait_for_flash_ready function when mobile phone is connected through BLE.
Please...
Hi everyone, I am quite newbee to nRF5340 and nRF ecosystem. Anyway, my goal is to talk with 3rd party application to receive positioning data over bluetooth and then I have...
Working with nRF52840 and nRF Connect SDK v2.1.0., whenever I enable MCUboot in the project configuration, the reset pin gets enabled on the next flash. I believe this has...
Hi,
I encounter a problem, in my opinion, related to the modem firmware (or model B0 and B1).
My program connects to the LTE-M network and sends data from a sensor.
...
Hi all.
I'm working on a Visual Studio project, written in C++, which I'd like to import into Segger Embeeded Studio.
I've done this before successfully, but this time...
hi support team,
customer reported one problem that when 5340 spi communication is done, the clock line is much longer than cs pin as below:
number2 is clock pin, and...
Hi,
In the example "nrf52832 light_switch_server" ,Does it have the function interface for the friendship node adervertise to all lpn nodes at one time?
hope your reply...
Hi there,
there is so many questions regarding BLE connection intervals, yet I couldn't find a precise answer to this basic question.
It seems to me, that multiple packets...
Dears,
I am working with nrf52 SOCs using nrf connect sdk.
I want to try the SMP Server Sample for OTA firmware update.
There is a tool called mcumgr-cli that cannot...
How are private keys stored on the nrf9160 modem? I've read in other forum posts and observed that the private key cannot be read out once set in the modem. Where could I...
According to this discussion, all the 4 UARTs are functional in nRF5340. I intend to use multiple UART ports, and I modified this exercise solution to do so. I was able to...
Hi new to this, so excuse the elementary question
Can I put custom software on a XM122 using the XB122 dev kit? This is the only hardware I have, is nRFUtil my only option...
