Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Hi,
1. Please provide me with an example in which UART0, UART1, uart2, and uART3 are enabled
2. The sending and receiving rate of each UART must reach 1,000,000 baud rate...
Hello,
I have been working with a BLE custom board project for a few months and the product requires buttonless DFU feature. The bootloader that I initially used was derived...
Hi,
I'm developing a project with nRF52832 and BOSH BME688 sensor.
I downloaded the library from github to use the sensor (here it is the link https://github.com/BoschSensortec...
Hello,
I am developing BLE peripheral Reader FW using nRF Connect SDK v2.0.0 on VSCode
I have developed my application using NRF52840 DK (development board) and it works...
Hi everyone,
Does anyone ever get confused about BLE connection interval? As explained in this post , it determines how often the Central will ask for data from the Peripheral...
Hi,
We have a board with ESP32 and nRF52833, connected via UART. We want to upgrade the nRF firmware via either BLE or UART. The nRF image size is large so dual image slots...
I am getting this error in Ozone:
"The target stopped in HardFault exception state.
Reason: A fault with configurable priority has been escalated to a HardFault exception...
Hi Team,
I'm trying to build i2c example code with nRF9160 using Zephyr RTOS. But when i use "west build -p auto -b nrf9160dk_nrf9160 sample/drivers/i2c_fujitsu_fram" to...
Hi All,
I am working on BLE+SD card Library, s132. Although i am getting certain errors which i am unable to counter.:-
*** Using Compiler 'V5.06 update 4 (build 422...
hello,
i have been using nrf52832 with sdk 15.2 , while different interupts occurs i have been changing the advertising bytes with different aid like this
m_beacon_info...
Hi, I see there are similar and narrow questions for specific chipsets: nrf5340 and nRF5240
Does this mean that Bluetooth LE Power Control (LEPC) feature is not at all...
hi:
Use the https_client routine to send data after the socket is established, and then send the data after getting the response. The errno returns as 128, which can confirm...
I've downloaded a fresh copy of NCS 2.0.0 and created a brand new application in an empty workspace based on the Hello World sample. The only modification I've made is putting...
Can I use SVC function in my application code to copy bootloader image into flash instead of using mbr commands? If this is not possible, what are the other alternative options...
