After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
Hello
This is sumanth. I am working on implementing battery model in light switch program(mesh), I enabled the battery model in client and I would like send the battery...
Hi, in the documentation for this module there is no stencil design specification or recommended
reflow profile. My earlier experience of LGA-modules says I really need...
Hello,
I want to get the IP address of a CoAP request source (server). According to me, it is close of the objective of the client / server pair mechanism example. So...
Hi, I'm having problems negotiating DLE with a nRF52840.
I'm sending a LL_LENGTH_REQ (251 octets and 2120ms time) to nRF52840 from an ESP32.
According to the spec. those...
Hi
I am using nrf52832 dev kit.
I have configured my device to act as peripheral. i want to discover services offered by central devices whichever connects to my device...
I am trying to use the PA/LNA using the pc-ble driver. To do so, i need to configure GPIO and the softdevice. I found examples:
https://devzone.nordicsemi.com/b/blog/posts...
I'm wondering about how the notification queues are allocated when setting hvn_tx_queue_size using ble_cfg.conn_cfg.params.gatts_conn_cfg.hvn_tx_queue_size.
If I set it...
\components\iot\socket\api\socket_api.h contains a definition for 'struct timeval' that conflicts with \arm-eabi\sys-include\sys\_timeval.h
It creates a conflict with including...
Hi,
This thread discusses how to change the Makefile to interact with the Segger Systemview ( https://devzone.nordicsemi.com/b/blog/posts/instrumenting-with-segger-systemview...
Enabling or disabling notification on Client does always lead to an update of local database of Server by writing to its flash memory. Particularly NUS requires enabling of...
Hi,
I'm following this tutorial . In challenge 1, I was asked to change the transmit power level of the device.
Challenge 1: Try to add and populate the "p_tx_power_level...
Hi,
I am trying to integrate some ble code into my project but it keeps giving me errors like:
Error[Li005]: no definition for "ble_advertising_on_sys_evt" [referenced...
While developing code for our custom board, we ran into a filesystem corruption issue with fatfs+qspi block device and multiple directories. We were able to reproduce the...
I have problems running the ble_app_uart_pca1004e_s112 on a custom nrf52810 target devivce. The custom nrf52810 target is a custom board with the Rigado BMD 330, which is...
