Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hi，i'm use latest ncs sdk to develop bluetooth application which use Periodic advertising, when i get started with samples(bluetooth/periodic_adv), and use Ellisys capture...
Hello,
Is AT+COPS manual selection mandatory or just a preference? We have an issue with 9160 choosing a network without PSM if it has better signal quality (when roaming...
Trying to flash devices and getting this error:
make flash
DONE nrf52840_xxaa Flashing: _build/nrf52840_xxaa.hex nrfjprog -f nrf52 --program _build/nrf52840_xxaa.hex ...
Hi,
In our old project we developed low energy sensors based on the Nrf52811 (nrf Connect sdk), using advertisements to broadcast the sensor data, then collecting them with...
Hi
I use the nRF connect SDK v2.0 installed with the toolchain manager and tried the distance measurement which works fine but doesn't use the high precision mode. I changed...
hello Nordic
i am working with zephyr NCS(1.7.1) , with vs code (on manjaro) with the nRF connect extension.
i am looking for a way to map my include files, to find dependencies...
While looking at ways to shrink the dfu image of our nrf9160 application, I was struck by how large the default SPM image is. Here's the file size breakdown:
Final app_update...
Hi I am successfully reading GNSS coordinates and sending them to AWS server. However, I have to stop gnss as soon as the modem goes into RRC Connected mode and resume work...
hello,
I am trying to access (Nordicsemi.com) website for downloading NRF CONNECT DESKTOP and COMMEND LINE TOOL software. but site not open.
still banned website.
please...
Hey there, I am using NRF52832 CIAA ( bga version)
I did some testing for internal DC DC ,
and found the following gaps
DEC1 - should be 1.3V , measured 1.27v
...
Dear support
I am developing a generic client, after connection and service discovery, there are usually a few characteristics with different uuids are found, I need to...
I'm trying to erase & write to the nRF5340 using the Programmer v3.0.0 but I get this error: Failed to load readback protection status: async task failure for id: 1198716183932...
Hello All,
I am facing an issue in nrf52840 development kit used as nrf Mesh sensor.
Issue details:
1. From the mobile application, we are setting the publish period...
Hi, I have an application that enable BLE (advertise and connectable) then disable BLE (disconnecte and stop advertising) every 10 second. My application worked when have...
