Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi Team,
I am using the solar beacon code from Nordic playground github for some reason and I know this is not qualified. I observe that the receiver suddenly misses a train...
Hello! When configuring using the 'Configurtion Server' model, the number of network transfers cannot be configured correctly. If set to less than 2 "NRF Mesh Android App...
![image description]
hi,
I can able to flash but when i try to debug by putting breakpoints its not coming out of this APP_ERROR_CHECK(err_code) function, attached is...
I'm using " no.nordicsemi.android:ble" and " no.nordicsemi.android:ble-common" on a tablet app, and had created a virtual device(Polar HR) on my iPhone with LightBlue app...
1.) I used the sample code for BLE peripheral uart as template for my own project and modified it. I removed the nordic uart service "nus" and replaced it with a custom service...
Hello every,
Currently, I want to Device Firmware Update via Serial. I am using DFU Example for mesh to generate DFU packet. I only Update for 1 device via COM port, not...
Good morning,
I am trying to figure out how to write unit-tests using NRF Connect and Zephyr on Windows. Therefore I am trying to use unity as described here:
http:...
I have developed a custom board using nrf52840 IC and I need to use UART. For this I have two pins available P0.19 and P0.20 to be configured as RX and TX. I checked those...
I am using a BC840 on custom PCB for a low power data logging application and am struggling to get lower than 270uA sleep current. This part has the 32mHz external crystal...
Hi,
The python nrfutil package doesn't seem to be actively maintained.
Latest updates don't support python version > 3.9 which are now default versions for latest Linux...
Hi,
I downloaded the project for PCA10040 with HID Mouse in ...\examples\ble_peripheral\ble_app_hids_mouse\pca10040\s132\arm5_no_packs . From Iphone and computer, I could...
Hello,
in my project i want to use watch dog timer in ble_app_uart_pca10040_s132 but am getting error as shown in image1, even after including driver files and paths
...
