i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
When using nrf51-ble-driver_win_0.3.0 with Visual Studio 2010, after I put a breakpoint in my code, when I try to have the process "continue", I always get unandles exception...
Hi all After successful installation of an update with the hep of dfu_target module, I am expecting the bootloader to swap the image and boot the new image with swap_type...
Hello! I have a nrf52840 DK. I am trying to build a custom keyboard on that SoC. I was able to compile and install nRF Connect SDK example on my DK. Everything works! ZMK...
Hello,
In continuation to the ticket: https://devzone.nordicsemi.com/f/nordic-q-a/70795/replacing-s140-with-s340-softdevice
I'm trying to switch between S140 and S340...
Hi,
I think I found a BUG about SPIM SDK15.3. The following is what I set the configurations for the SPIM0:
Then I use this function to active one transfer which just...
Hi,
I'm using nrf connect SDK 1.7 and following below guidelines to add I2C.
https://devzone.nordicsemi.com/nordic/nrf-connect-sdk-guides/b/peripherals/posts/twi-ic2-implementation...
Hi,
we have few queries regarding lighting mesh models support in ncs1.6.1
we were using NCS1.6.1 for mesh development
we were facing some compilation issues with LC...
I am using nRF52840 Dongle as Sniffer using Dongle. But when it captures the advertising packets,i am not able to see the preamble in the decoded packets. Please help!
Hello Everyone
I am really new to everything here, i just got nRF 9160dk board.
Can anyone please tell me the step-by-step method on how to make a very simple program...
Hello DevZone,
I am planning on making a system that uses peer manager ranking to determine which oldest bond I need to delete to make room for a new one.
I am using...
Hi Team,
we're developing firmware to send long range beacon by using LECODED phy channel. We notice that there is increase in energy consumption during advertising and...
Goal: Using NRF9160DK board, communicate nrf9160 and nrf52840 over UART
I tried to use UARTE on both sides. Below is project configuration and overlay file for both boards...
Hi,
I was using the AWS-IOT example and all was working until it wasnt. In troubleshooting this, I loaded the modem shell example, to see if it was a network/connection...
Hi everyone,
I implemented nrf5_SDK_17.0.2 ble_app_uart example, so I connected an external device to my nRF52840 DK and I received the data by my android phone.
Now I...
