i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
When using nrf51-ble-driver_win_0.3.0 with Visual Studio 2010, after I put a breakpoint in my code, when I try to have the process "continue", I always get unandles exception...
The current platform of the AOA contains 12 antennas multiplexed into one 52833 module
The distance between each antenna is small, hence the angle delta that can be detected...
Hi Nordic Support Team,
It can connect and read the Service UUID and Characteristics UUID, but when I am trying to do the DFU update on the iOS (iOS 14.5) but it will disconnect...
Hi,
I am developing the system where I am sending the data of three sensors to the server using MQTT. For the above development, I used two microcontrollers one to collect...
Hi Nordic Team,
I would like to share with you a minor challenge that we are facing to use the nRF52840 dongle with a Zigbee Mesh network and issuing a serial communication...
Hello,
Does anybody know where I'll be able to find an EAGLE library for the nRF52840 CKAA chip (the WLCSP-93 package)? I've looked around and all other dev boards that...
Hi,
I'm having doubts about whether to use NUS or OTS to transfer 500 bytes of data from the peripheral device to the smartphone. Regarding OTS, I've tried using the ble_ots_central...
Hello.
I am developing using nrf52832 (S132 v7.0.1, SDK v16.0.0) as a central and Android device (Bluetooth 4.2) as an advertisement.
During development, I was wondering...
Hello,
Following is my hardware and firmware setup.
Thread BR:
PCA10100 v1.0.0 connected over J-Link microUSB port to RPi 3B+
SDK v4.1.0
Thread Node:
PCA10100...
Hi,
If using a serialization connection to a BLE module. The application will run on the host MUC and the BLE module only runs the SoftDevice (BLE stack). I understand that...
I'm running the unmodified blinky example on the 52840 dongle PCA10059 and it connects just fine with the nrf connect app but will not pair with the phone via the Android...
Excuse me:
When I was testing the OTA of nrf52820 chip, there was a download error in the command line tool。Here are my steps in nrfjprog tool：
1、nrfutil settings generate...
