After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
just like the title,we are using nrf52832, but for some reason, we have to use both ble and 2.4G, we found pca20001 using both ble and 2.4G, but it's work with nRF51822, any...
I ran the sniffer software ble-sniffer_win_1.0.1_1111_Sniffer.exe and was able to select the device and sniff the advertisement and the BLE connection. But after the connection...
Hi, I would like to know if there's a way to change the size of a transfer with the app_twi library.
For example if in a function I have this code :
static app_twi_transfer_t...
Hello everyone,
We want to develop a wearable product using nRF51822, we found there are 3rd party module mentioned on the Nordic Semiconductor. And there are some development...
Where could i buy the rev 1 of nrf52832 DK? I can't find a place where they specify the revision or the packet variant and the build code. Is there a way to know?
Is it possible for a nRF51822 device running a Gazell stack (as host) to be able to receive RF waves from another device which is not running a Gazel stack?
If yes, then...
Hi, I use S110 to develop a product which will send data to master every 30s. I registered a 30s App timer at RTC1. When this event occurs, I can control the IO pins but cannot...
Hello,
I have a question for a nordic employee:
What is the factory flash state of a nrf52 chip ?
Is there any pre-programmed bootloader ?
With other processor, for...
hi,
I created a SDR/GR based basic BLE dumper. fell free to use and improve it :)
github.com/.../ble_dump
(output to pcap or fifo -> wireshark (btle= (default in...
Hi all,
Is there any example how can I communicate with 51822 device with SD110 on Windows 8.1 desktop? I successfully paired the device but I have no idea where can I...
Hi, I am trying to implement Secure Connection for my application, because using PIN I noticed some problems with the bonding in iOs, in fact using the device manager from...
I've writen a BLE program for a company,they reqire me to certificate the circuit and the program through a Fixed frequency program,what is the hell?Where to get it?
Hello,
[Device: nRF18522 S110 Softdevice 8.0.0 SDK10]
I've referred to this post:
devzone.nordicsemi.com/.../
Does it mean the maximum value is 512 seconds...
