Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Using nRF51822, I define keys and pins as follows:
Keyboard key
Mouse left/right key
Mouse move (up/down/left/right)
Media play/pause key
Pin 0 Mouse...
Background:
Over the past few weeks, I have been working on enabling TLS1.2 for an nRF9160 with Ethernet (W5500). My primary objective is to have both Ethernet and LTE...
Hello everyone,
Currently we're trying to get the full WiFi stack working on nrf7002dk. We decided to look into the power consumption of the DK board itself as a point of...
The Nordic Thingy:91X board has a Nordic nmp1300 pmic device, but the samples do not support the board (a lot of time would be saved it they did);
https://docs.nordicsemi...
Hi Support Team
Does nRF5340 support UAC(USB Audio Class) protocol? We want to input audio to nRF5340 via I2S and PDM and then output the audio to a PC via USB. Can the...
I would like to save about 100KB of data in the on-board FLASH of the nRF9151 SiP. Can you point me to the memory map and how I can partition the space?
I would like to create either a receiver thread that only monitors incoming/MT data OR setup a callback function to receive all incoming messages. Does such a thing exists...
I am using a custom nRF52832 board with NCS v3.1.0 with the following BT configs:
# Enable Bluetooth CONFIG_BT=y CONFIG_BT_PERIPHERAL=y CONFIG_BT_GATT_CLIENT=y CONFIG_BT_DEVICE_NAME_DYNAMIC...
Hello,
im trying to install the credentials into my nrf9160 , the error i get is this one : Failed to obtain CSR from device.
How can i solve this issue? I have also...
I do step-by-step elements from https://academy.nordicsemi.com/courses/nrf-connect-sdk-intermediate/lessons/lesson-9-bootloaders-and-dfu-fota/topic/exercise-5-fota-over-bluetooth...
I am trying to implemented a mechanism for authenticated debug on NRF52840 on NCS 2.5.
My understanding from the product specification is that DAP protection is enabled...
HI，
The current SDK version I'm using is 3.0.0 for nrf54L15. I want to control the SPIM30 using DPPI, so I'm using the nrfx library to operate the SPIM30. The specific code...
Hi,
We are experiencing a weird issue on our custom boards which have a nrf9151 chip
We are using emnify sims and have experienced the following:
On some boards, when...
Currently designing around the nrf54h20 and wondering if Nordic has any recommendations for properly routing the USB D+ and D- traces.
D+ and D- are supposed to be routed...
First of all I am very new to all of this and have been reading up a lot on the topic.
I am trying to create a walkie-talkie like setup where 2 development kits will communicate...
