Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
We are using SDK15.0.0 and have products with both the NRF52832 and NRF52840 sharing the vast majority of code between them. The softdevices we use are S132 and S140 at version...
Hi,
The nRF52840DK-2.0.1 is not working/turned on.
it works intermittently, and keep on connect/disconnects continuously after sometime.
I suspect the SW9 switch is...
Hi,
is there a way to send some status data from the headset to the gateway in the nrf5340_audio application?
We would like to monitor the battery voltage of the headset...
I'm trying to go through the proes and cons of a Hosted Vs Hostless Solution for BLE using the nRF52840. I have an AP thats running a stripped down version of Linux. Currently...
Dear Engineer,
Working on sdk17.1, hrs free rtos demo. chip nrf52832, on pca10040 board.
From Sdk 17.1, log not resume in application hook to save power.
Use log_pending_hook...
I use the PPK2 to measure the power supplied from a lithium polymer battery to a test device. I use 'Ampere meter' and the 'Enable Power Output' switch in the UI then 'start...
Hello,
I am using SoftDevice S140 SDK 7.2.0. I need to initialize the no init parameters.
For doing that I used nrf_power_resetreas_get() return parameter. Two questions...
Hi,
The memory space of the application core for nRF9160 is empty.
Now,if I set the ERASEPROTCET register located in the UICR to 0( Erase protect will be enabled.), how...
I have a few issues/suggestions for improvement of the VSCode extension for Nrf Connect, that I like to submit to the developers : I tried the github link https://github.com...
Hi
In my firmware, i setup a NUS service, piece of code as below:
I found that the nus_send_enabled_cb function is always invoked before connected function...
