Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi,
I'm trying to get latch functionality working on two GPIO pins, but cannot seem get the latch register to behave consistently.
I have my GPIOs configured using a custom...
Hello All,
I have following question
What is the Bluetooth SIG Host Sub System QDID of the chip nRF52832 with software: Nordic SDK version 8.24.1 and nRF Softdevice...
Dear Support team,
I am using the NFC Tag of the nRF52840, CKAA F.
What is the maximum rating of voltage and current of the NFC Tag?
-> I set NFCPINS.PROTECT = NFC which...
Hi!
What is the easiest way to compare two sdk_config files? Some tools, etc. Why do I need it:
My idea is to use "$NRF_SDK/config/nrf52840/config/sdk_config.h" as base...
Hi. Currently I am been getting NRF_ERROR_NO_MEM on nrf_sdh.c:391. I am using the nrf5 SDK 17.0.2 and the nrf5 SDK for Mesh, working primarily on the nrf52840 DK.
So currently...
Hello,
Is it possible to use the CONFIG_MPSL_FEM_NRF21540_TX_GAIN_DB config option on the app core only? Meaning if I have a proprietary controller, is there a way to adjust...
Hi Team,
I am working on NRF52832 based on the BLE mesh protocol here I am using the Light_switch example of SDK - nrf5sdkformeshv500src
Here I need to send the message...
I am connecting to the ble device from the PC through pc-ble-driver-js .
There, I am using the nrf52840 dongle with Connectivity firmware, and the wireless performance of...
good day,
is it possible to change the assigned DFU button (Button4) to other button or gpio in the secure bootloader example? if yes, where do i need to do it?
thank...
Hi,
I want to use the functions app_uart_get() and app_uart_put() to communicate between the computer and NRF52840.
But when I type a string on the computer, the app_uart_get...
As I found inconsistent information about it, I would like to clarify this:
Is the nRF52840 compatible to both Bluetooth Classic as well as Bluetooth Low Energy?
Would...
Hi,
I have a nRF5340-DK with a ATSAM3U2CA interface MCU as an on-board debugger.
For the nRF52840-DK, the interface MCU firmware is available to download: https://www...
