Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi,
i tried to send data from ios 7 via tx_characteristics(like in UART example) but received error:
didWriteValueForCharacteristic 2A38 error = Error Domain=CBErrorDomain...
I have been trying for a few days now to get my environment setup for development with the nRF51822. Since there is no official configuration for the Mac w/ Eclipse I have...
Apologies if this has been asked before but did search for 'format' in faq and got nothing.
I have been answering to questions.
In my answer I place hard empty lines....
Hi
i use nrf51822 s110 "hrs" example to transmit the data to ios.
I need to add an option to send back some data (from ios to nrf51822). 10 bytes maximum .
how can i implement...
Hi
i use the hrs example to transmit the data to ios.
but i need to add an option to send back data (from ios to nrf51822). 10 bytes maximum .
how can i implement...
We are using SDK15.0.0 and have products with both the NRF52832 and NRF52840 sharing the vast majority of code between them. The softdevices we use are S132 and S140 at version...
Hi,
The nRF52840DK-2.0.1 is not working/turned on.
it works intermittently, and keep on connect/disconnects continuously after sometime.
I suspect the SW9 switch is...
Hi,
is there a way to send some status data from the headset to the gateway in the nrf5340_audio application?
We would like to monitor the battery voltage of the headset...
I'm trying to go through the proes and cons of a Hosted Vs Hostless Solution for BLE using the nRF52840. I have an AP thats running a stripped down version of Linux. Currently...
Dear Engineer,
Working on sdk17.1, hrs free rtos demo. chip nrf52832, on pca10040 board.
From Sdk 17.1, log not resume in application hook to save power.
Use log_pending_hook...
I use the PPK2 to measure the power supplied from a lithium polymer battery to a test device. I use 'Ampere meter' and the 'Enable Power Output' switch in the UI then 'start...
Hello,
I am using SoftDevice S140 SDK 7.2.0. I need to initialize the no init parameters.
For doing that I used nrf_power_resetreas_get() return parameter. Two questions...
Hi,
The memory space of the application core for nRF9160 is empty.
Now,if I set the ERASEPROTCET register located in the UICR to 0( Erase protect will be enabled.), how...
I have a few issues/suggestions for improvement of the VSCode extension for Nrf Connect, that I like to submit to the developers : I tried the github link https://github.com...
Hi
In my firmware, i setup a NUS service, piece of code as below:
I found that the nus_send_enabled_cb function is always invoked before connected function...
Hi,
We're really stumped on this one. We recently deployed 150 devices running nRF SDK for Mesh. All except three of these devices are running a modified SimpleOnOff Server...
