Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hello,
In the document about Release assistance indication %RAI. It says
In addition to using the %RAI command, the application must tell when the data connection is...
Hi,
I was using NCS 1.5.0 and Modem firmware 1.2.3.
I have latest DK of nRF9160.
It was running properly without issue specially LTE connection.
But after I migrated...
Hello,
i ran nRF Coap Client and it worked pretty well.
I am working with nRF9160 DK.
Now, I want to add DTLS to this example to secure the data.
Can someone please...
Hi.
I wasn't sure under what topic to post this but it's just a generic question I suppose. I'm still learning so please give it to me in plain English.
It took me a while...
HI Nordic,
As far as I know, in nRF5SDK, the maximum link number of BLE is 20.
I search for the devzone, someone said the number for NCS is 64.
So, I want to know: ...
At multiple places in the SPM subsystem code incorrect assumptions regarding the SRAM memory layout are hard-coded:
At line ~35:
This code is enabled when USE_PARTITION_MANAGER...
Hi.
We are working in a project that needs to exchange data via serial port. In this sample a virtual serial port is created in the nRF USB connector. Is it possible to...
I have custom board with nrf52833 SoC. its works fine with all example of NRF SDK1.7.1. except with ZigBee examples it did not works. I run Zigbee:Network coordinator with...
Hi,
I would like to know if it's possible to use the nRF52840 chip in nRF9160dk to join/create openthread network. When I tried flashing the thread CLI sample to the nRF52840...
Hello everyone,
I started with my program on the nrf52832. As a base I use the example multirole_LESC, because my focus is that 2 or more nrf52832 communicate with each...
Hi,
I want to storage some data in flash on nRF52810. When I open the "flash_fstorage" example and built it, there occur an error.
RTE\Device\nRF52832_xxAA\system_nrf52...
