hi support team,
customer is testing our nrf93M1 module, and find out, when device enters system mode after sleep, there will be a lot of URL sending to UART as below: ...
I'm not sure if I can share the files here, but you can email me at kc6ete at gmail if you want a copy It's a four color print designed for the Snapmaker U1 though it can...
Dear Team,
I have been running two nRF54LM20-DK as Initiator and Reflector for Bluetooth Channel Sounding.
I adjusted the ranging algorithm RAS_Initiator to print Local...
Hi,
I'm trying to find out how people automate current measurements with the PPK2 beyond doing it by hand in the Power Profiler app.
From the threads here it looks like...
During the setup process for nRF Connect SDK v2.4.0, an error occurred preventing the SDK from installing correctly.
The environment details are as follows:
* macOS...
Hello,
I would like to understand more about a topic which has been covered here many times. Since I haven't found an answer I wanted to dig a bit deeper than the RSSI vs...
Hello everyone,
I am working with the nRF5340 DK as well as the SDK version 2.2.0.
As I would like to implement a UART communication in my project, I tried to run a UART...
Hi,
1. Does nRF52833 have an Omni Antenna reference design?
2. Does ceramic antenna have an Omni Antenna reference design?
3. Does FPC antenna have an Omni Antenna reference...
Hi, I'm relatively new to nRF products and embedded systems and right now I want to try out programming a adafruit feather nrf52840 express with a nrf52dk (52832) board and...
Hello!
In our application the last two sectors of the APP core flash are used to store non-volatile config information (from 0xFE000, 2x4kB). I've created the appropriate...
Hi,
I have two nRF52840 dongles. Both configured to use external power source (SB2 cut, SB1 soldered).
The first one goes always to my nRF program on power on (battery...
I'm looking for some feedback. We are running a pilot with 38 nodes in a Bluetooth Mesh. The building is a roughly square layout with 4 main corridors following the outside...
Hi. I am testing the NRF5340 DK using NCS 2.2.0. DK operates as a peripheral device, and the controller tries to use the smartphone App. I created a custom service and created...
ble_rx_thread(SystemWrokq or recv_workq_bt) is cooperative priorities thread in nrf connect SDK
I want to know why. Also, can I change the priority of the thread to preemption...
I am running SDK 16.0 on nrf52840. For GATT Writes I am using the BLE Gatt Queue Library. When I try to performing lots of writes in succession some packets do not get transmitted...
I am validating a prototype with nRF52840
I hand soldered the nRF52840 (QFN package) and few passives to make sure I can connect with SWD to the microcontroller
Currently...
nRF52840, SDK17.0.2, SD140 v7.2.0
We're migrating from RTT to UARTE for our device-to-host logging, and I'm using nrf_libuarte_async.
When an asynchronous TX completes...
