Hello,
After I upload a new signed image to my device using MCUboot serial recovery (single image), MCUmgr Img_mgmt_client API
img_mgmt_client_state_read() always fails...
Hi Nordic team,
I am plan to design an IoT sensor that apply to Agriculture,
In case of 2 communications: Near field and far field, I will integration both BLE and Lora...
Hi
Are there any examples of a custom board for nRF54L15?
I have a project built/running on the nRF54L15 DK.
I now want to create a custom board for the nRF54L15.
...
Hello,
I am working with a custom board that has the nRF52840 (via the ISP1807-LR-RS module). This board has the SIT1552AI-JE-DCC-32.768E MEMS TCXO. This TCXO chip has a...
It would be extremely useful to get the HCI Traces (BLE) of my nRF54L15 boards. Documentations: Embedded HCI Tracing For simplicity's sake, here is my setup: - nRF54L15DK...
Hello there,
I'm designing a set of devices composed of a remote and 2 peripheral. The remote's job is to be connected to the 2 peripherals as a central and occasionnaly...
Hello, I’m testing a PID controller for a quadcopter. When I compile the application with the optimize for speed then flash, I notice that the PID response is slower than...
I am developing an nRF52832 application requiring two separate quadrature encoders interfaces. The included nrfx QDEC driver would work just fine and it would save me a lot...
I have the following statements throughout my code.
printk("Temperature(BMP280): %3.2f %s\r\n",tempFloat,tempUnitsCentigrade?"C":"F");
I would like the format %3.2f...
Hello, I am using the nrf52840 board and SDK(sdk_v15.3.0 and formesh_v3.20).
I have tried to transfer the vendor model status message to the client from the server.
Following...
My nRF 9160 DK is being detect by my computer. And my computer detects that the J-Link driver is connect. But the nRF 52840 is not appearing in file explorer. I'm not sure...
Hey guys,
I have a timer like this:
While this first timer (nrf_drv_timer) is running, I need a second timer whose interval I have to be able to change constantly. ...
Hi
when I try to use printf in the secure wold my nRF9160 resets. I assume that something needs to be configured differently but I don't know what.
The skeleton of my...
I am working with the light switch example and am having some issues surrounding node configuration, namely getting the composition data.
Setup: 1 client/provisioner (both...
I got the dev board all set up and working - managed to program a few examples flashing LEDs etc…. So then I wanted to do a BLE peripheral beacon example and it told me to...
I'm looking at designing my own Bluetooth Receiver essentially. Playing music from my phone to a Bluetooth receiver, to output via AUX.
I was looking at the range of MCU...
Hi,
For my all DFU i follow the steps on the Getting started guide , just in the Performing DFU step i use the nrfutil tool for the over USB.
First i tried with the DFU...
Hi team,
Similar to how we have recommendations to use certain pins for low drive, low frequency on the nRF52 series, do we have those recommendations available for the...
nRF connect is not recognizing my nRF9160 board when I try to use the programmer tool. It allow me to select it from 'select device' drop down menu. But then I select it all...
Hi,
I am working with NRF52832 boards where on one board i have loaded Multilink central example, and on the other i have loaded peripheral code with some modifications...
