Hi all,
I'm deploying an nRF9160-based device in India and hitting the familiar "which SIM actually works here" wall. Looking for current (2026) experiences, since older...
Hi all,
I've built a custom nRF9151 board, which is successfully responding to the basic factory AT commands. It won't accept a CFUN=1 command though, presumably because...
Hello!
I think there is a problem in NCS v3.3.0. nRF54L target, sysbuild build with MCUboot and TF-M, partition layout coming from devicetree (SB_CONFIG_PARTITION_MANAGER...
Hi, I'm developing a keyboard-pcb with NRF52840. I'm doing this as a hobby and are not that experienced with integrated circuits. Anyway, I designed and produced a pcb, but...
Hello,
in cases where the LTE signal strength is extremely low, we observed that the LwM2M /4/0/2 RSRP rolls over from -128 to 127. We found that the nRF Connect SDK uses...
As part of the Bluetooth LE course we need to setup and install the nRF BLE sniffer for wireshark. I have followed the explained steps in the course to set up wireshark to...
The at command documentation says that ENVEVAL is only available in system mode 2 (CFUN=2). Is there a reason why the command can't be run in any other mode? For example if...
Hi,
I just found out that the scanning procedure does not time out in SDK 15. This is because in SDK 15 we are forced to restart the scanning procedure everytime an advertisement...
I am using nRF5 SDK for Thread and Zigbee 2.0.0
I am having trouble commissioning using NFC, either with the nfc_meshcop example or my own code (based on the nfc_meshcop...
Hi we are trying to test the serial boot loader example from sdk 11,sdk 12.03 non of them working while running using nrf go studio it says enter in dfu mode and while we...
Hi, I want to use the p0.18 as a GPIO without being connected to nRESET function. So I removed "CONFIG_GPIO_AS_PINRESET" from the define option in Keil. And then i found that...
Hi there,
due to unknown reasons, my nrf52840-DK (1.0.0) didn't come back up after flashing software to it. Means the LED that usually turns on when you power it up remains...
Hello All,
I am having issues compiling the "light_switch_client_nrf52840_xxAA_s140_6.1.0" and "light_switch_server_nrf52840_xxAA_s140_6.1.0" example found in the Mesh...
Hi All,
I'm new to nRF52.
I'm working on nRF52 PCA10040 board. How want to how the secure bootloader works?
I tried to load application from DFU serial bootloader and...
I'm trying to use the sample application "\ ble_central \ ble_app_rscs_c".
If I change the NRF_SDH_BLE_CENTRAL_LINK_COUNT file from 1 to 2 in the sdk_config.h file, the...
Hi,
I am new to openthread development. My goal is to distribute measured values received from the SPI Bus over a thread network. I am using a nRF52840-DK Board, SDK for...
Hi, I have recently purchased flasher portable plus to use this device in prodcution to flash devices consisting of nrf51822_xxAA. Here are my following questions
I could...
Hi all,
I am new to BLE development. Currently developing a new BLE device using ISP1507, which is based on NRF52832. The device (server) will be communicating with a Windows...
