I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hi
I have my code like this .
unsigned char *encryptedData;
unsigned int encryptedDataAfterAppendingLength;
memset(encryptedData, 0, encryptedDataAfterAppendingLength...
Hi,
we use the GPIOTE to get informed if the value of a GPIO pin gets from hi to low.
If this happens, the GPIOTE event handler will be called.
What will happen,...
Hi, I'm using a nRF52 dk board as a switch to control a circuit. The problem is I not sure which gpio can be used to act as a switch to control the circuit. Thanks.
I need to append another binary-file (image.bin) to the generated bin-file from my own nRF makefile Project in Eclipse with Cross ARM GCC. My research showed me several possibilities...
Hello,
I have a standalone application which incorporates 3 public BLE services and 2 services with custom UUIDs.
Today I tried to extend the buttonless DFU example with...
Hello,
I have installed Ozone (V2.22g) on Kubuntu (16.10 64bit) and attached a nRF51DK via USB. I can successfully run a test program using nrfjprog with the following...
Hi,
I'm not sure if I understand the new reference layout correctly. There are new NP0 12pF capacitors on pin 25 and pin 26 to suppress the spurious emission, but are they...
I'm trying to flash the nrf52832 with a SWD debugger called Atmel Ice . As a reference, I have the Laird BL652 dev board .
I was planning on flasihg the nrf52832 by using...
Hey,
Could you please explain, in your reference designs, why you suggest to use solder mask clearances that cannot be produced?
0.045mm is not possible produce and...
BLE_Nordic.zip Hi,
We are a couple of students trying to implement NRF8001 in our project, we made a SPI setup on our Atmega328p to communicate with the NRF.
After sending...
How does a multirole component behave if it is set to continous scan and advertising every 400 ms? This is pr. definition a contradiction!
My question is whether it is...
