Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
I'm trying to slim down my application to fit in an nRF52832 (currently overflows RAM when building) so I'm carving things out using the prj.conf file. But I'm running into...
Hi Nordic team,
I hope you’re doing well.
I’m new to embedded development and I’m currently exploring the nRF52 and nRF54 series for a future product line. My idea is...
Hello,
I am unable to use the Segger RTT terminal built into the nRF Connect SDK for VSCode Extension pack with the nRF54L15DK.
I have configured my project with the...
I'm having an issue while trying to install the nRF Connect vsCode extension. I assume that extension has auto board detection feature. However, on my computer, this feature...
Hello,
We have a custom PCB that includes an nRF9160 and nRF7000. We’re planning a hardware update to add external flash memory and would like to know if we can use the...
I have a very complex nRF project inside VS Code using the nRF Connect extension(s). Frequently while trying to troubleshoot things I will run across instructions along the...
Before initializing training for a new Neuton model in Edge AI Lab there is an "optional" training stop option. However, I wish to train my model longer than that and therefore...
I recently designed and ordered custom nrf54l15 board but i cannot connect it through JLINK
It randomly throughs error like
```
(base) [ 10:18오후 ] [ yeonfish...
Hi, I am trying to implement MUSIC into the sample, and I have a problem with the net buffer allocation. Is there a way I can solve this via Kconfigs?
I am also attaching...
We are currently evaluating thingy91x connectivity in different locations, using some Simbase multi-IMSI sims and are running into an issue where, sometimes, the modem will...
Hello!
One of our clients requested the certified measured EIRP (Effective Isotropic Radiated Power) values of the nRF24L01+ 2.4GHz transceiver, which is used in our products...
Using nrf5340 with nrf70 on a custom board, using NCS 2.9.0 (and I can't/won't update to 3.2.x as the nrfx4 update breaks all my code)
I want to use the wifi interface to...
I have an application in which there are two high speed sensors consider it as sensors 1 and sensor 2. Both sensors are connected over same SPI lines having different CS pins...
