Hi,
Is it possible in BLE channel sounding in ncs 3.0.1 to get some information about the quality of the distance measurement for each method? We have three ways to get...
Hi,
my name is Nick De Leenheer, and i am finishing my thesis on indoor localisation with CHANNEL SOUNDING. i currently got these outputs in my venv using SERIAL: so i...
Hi,
I´m working on a Zigbee-based environment sensor. You can find all related files here: https://github.com/Kampi/BeeLight
Now I have the following scenario: the whole...
Does the nrf54l15 have a register to specify the boot area? Similar to the NRF_UICR->NRFFW of nrf52833.Or does the nrf54l15 have to boot from address 0x00000000?
Hello,
I've been going through the BLE fundamentals course and things are going well. I'm using the nRF5340DK board and SDK version 3.0.2
I've gotten to lesson 3, exercise...
Hi,
I am working on the channel sounding feature on the 54l15 and I want to perform it sequentially between 3 reflectors and one initiator. I realized that after I make...
Hi,
We're at a point in our project where we're working through some regulatory testing for ETSI/FCC certifications with our BLE dongle board (nRF52840 + nRF21540 FEM...
Hello!
I am putting (with a wave generator) a square wave on pin 17 of the microcontroller, and I want that same wave to come out on pin 18. How do I do that? Do you have...
Hello,
I need to transfer a lot of data over USB. I configured the USB as a USB_CDC_ACM on the nrf52840.
Everything works but the problem that i'm running into is that...
Hi there,
I'm currently using micro-ecc on an nRF52 compiled using Nordic's makefiles and implementing the secp256r1 curve. I'm mirroring this in Node.js using the Crypto...
Hey,
Can the nRF52 support 'Thread' / '6LoWPAN' protocols in the future?
Can the component support it (PHY wise etc) with the right 'softDevice' stack drivers?
Thanks...
I have used nrfgo studio, nrfjprog, jlink commander. Whenever i try, it is unable to find the jlinkarm.dll. i have checked the registry, reinstalled everything, but same error...
I use example ble_app_uart_pca10028_s130, I want to change the connection parameters by changing #define MIN_CONN_INTERVAL, #define MAX_CONN_INTERVAL, but when I use oscilloscope...
Hi,
I have been using the nRF51-DK to develop a program for capacitive sensing. I want to design a custom PCB with the nRF51422 chip on it. Do I need to have an oscillator...
Hello,
Using NRF52832, I need to convert to BLE 19.2 kbits / sec bit stream, received from another processor UART. I need a sample program, which I can adapt to do this....
Hi I was use example ble_app_uart with SDK 12.3.0 and nrf51802 for a data transport, after BLE connection, the example need uart receive more than 20 or "\r\n" ,the data will...
