I've been unsuccessfully trying to serialize BTLE example programs by SPI. I have two PCA10028 boards and I'm using SDK10. In addition to serialization examples, I've tried...
Hello,
Connection between linux router and NRf51 devices worked before I've updated kernel version from 4.09 to 4.3.
Now, with the same configuration and hardware, I'm not...
Hello,
Connection between linux router and NRf51 devices worked before I've updated kernel version from 4.09 to 4.3.
Now, with the same configuration and hardware, I'm not...
Hi
Does anyone know a CE—certified module based on the nRF24LU1+? Ideally, it should have an SMA connector, but any kind of antenna would be fine.
There are many modules...
I am running peripheral example radio test example on PCA10001(part of nRF51822 Evaluation Kit). using nordic sdk v7.
I am using mincicom on linux at baudrate of 38400...
Hello!
I am trying to get windows phone work with nrf_uart example on nrf51 dk board (pca10028).
I am using SDK 9.0 with S110 softdevice ver. 8.0.0.
I was using examples...
Hi
I met a problem when I use my new board,I found that the example in the peripheral folder in SDK can run correctlly,but the the example in the ble_peripheral folder...
I have the CLI module over UART enabled, with one command that continuously prints out the readings from a sensor. What I'm trying to do is stopping this continuous printout...
Hi,
I am using the nRF52832 and am going at it barebones because I cannot for the life of me get the SDK to work. I am using the nRF52832 manual.
-> Manual
I have two...
Hi, Im using a nRF52DK to read LIS3DH accelerometer readings in putty. Im new to this platform, I tried couple of example programs like blinkey, uart, and button in BLE. Now...
Dear All,
I am trying to implement a simple data recorder on nRF52840 DK that digitizes signals over SAADC and writes them onto the SD card. The program is working fine...
Hi,
Does anyone know where to find the BLE backwards compatibly of a given soft-device ?
I have looked at the PDF document given for my soft-device version S132, and...
Hello,
I am running an application on the s140 soft device using the buttonless dfu as an example. I am using the dual ramp pwm scheme to generate complementary pwm waveforms...
I'm having some issues with the 9160 on battery and wondering if we're doing something wrong or if this is expected behavior. During the initial connection to the tower, I...
We tried to adapt the RTC example from the SDK to add logging via UART during interrupts and the programmed crashed or hanged.
Here follows the code we are using :
The...
Hello, I have an application based on the example "ble_thread_dyn_mtd_coap_cli_pca10056_s140".
When a confirmable message has not received a response, I receive the error...
Hi,
We have built an iOS app with the iOS nRF Mesh Library ( https://github.com/NordicSemiconductor/IOS-nRF-Mesh-Library ) that collects data from all the sensors in the...
I am using nrf Toolbox iOS demo application. I have a requirement in which I want to change the incoming data stream to accept 4 bytes of data instead of the default 2 bytes...
Hello,
I am migrating our production code from SDK14.2 to SDK16, and switching to using FreeRTOS. During the BLE initialization and bonding, I get a system reboot. Tracking...
Hello,
Using an Arduino nano 33 ble which contains a nrf52840.
Using arm-none-eabi-gcc version 9.2.1 in debian/linux, uploading using openocd en gdb.
I tested my problem...
