But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi All,
I have been using the fatfs examples to write data to a SD-CARD Using SPI, Up until now I have been able to use effectively, as per the documentation I Understand...
I don't know how to manage the Bonding key. I confirmed the following sequence, but it is abbreviated as "Keys stored in keyset". At what timing and how should I get and save...
Hi guys,
I am creating an application that can enable my device to measure the voltage and temperature, after I am able to send these data via BLE to my mobile app (nRF...
hello Nordic
i am working with nrf52832, sdk 6.0, softdevice s132 v7.0
i read around the forum that i can advertise a beacon packet every 20 ms
but in the ble_app_beacon...
I was using MBED TLS crypto library for various cryptographic stuff and hashing. It was working fine with SDK 1.2.
I tried to port my code to latest SDK 1.3 and I am having...
Hello
I'm now going to read PD_SCK and Dout from Hx711
but i can only get the value from PD_SCK, no value from Dout
here is my code, using NRF52810 and HX711, hope someone...
I have currently building and am running the SPI Transaction Manager Example (spi_master_using_nrf_spi_mngr_pca10040) on the nrf52 pca10040 board, where is information for...
hello Nordic
i am working with nrf52832, sdk 16.0 s132
1. i see when i use the app_time i have to initialize it using this line of code :
though i thought and...
Hello, I updated a working project based on nRF52832_xxAA 32Mhz crystal, from SoftDevice S132 5.0.0 to 7.0.1, (set preprocessor NRF_SD_BLE_API_VERSION=7)
now the sd_softdevice_enable...
Acctually, I use nRF5 SDKs for transferring IMU sensrsor data via bluetooth to mobile app. When I check the license of source codes, the components kiibohd controllerv0.5...
Hi all, I swear I've read every post under the sun regarding this, and tried so many different things from all of them that my project is probably slightly screwed now. I...
Hello!
I am trying to run the experimental ble_app_hrs_nfc_pairing example from SDK17.
I am using an nRF52832 module and SoftDevice s132.
The example compiles fine...
Hi! I'm trying to get a basic example to show the 9160 going into the System Off mode and then waking up when a button is pressed. However I have not been able to get the...
