Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm attempting to use AWS IoT Just In TIme Provisioning(JITP), but no luck. Any help.
I tested JITP on my account, not Nordic one, with local mosuqitto client on Mac and...
I'm trying to use aws_fota, but it doesn't work. Any help?
I was able to set a job on AWS IoT, but the download job doesn't start. The job status is always "in progress...
Hello
I am writing a peripheral emulator application on android. My peripherals include 2 services and 4 characteristics. I tested my application with nRF Connect on the...
Hello All,
I am working on nrf52810 board
Using sdk 14.2
I am trying to modify some bytes of advertising packet .
I am referring the previous post as link given...
I'm getting ERROR 12 upon calling ble_advertising_init. I understand that this is caused by exceeding the advertising packet max payload of 31 bytes. What options do I have...
Hi All,
I am testing the performance of a Relay Node in a mesh network.However it seems don't work.
I would like to show that the Relay node operation such as Rx and Re...
I am working on nRF52832 platform and my version of softDrive is (nRF5_SDK_15.3.0_59ac345), I am wondering in my application what is the data packet length and can Increase...
I have flashed my Thingy:91 via the nRF9160 DK using the Programmer with the pre-built at_client software, but I am unable to get any AT response when I connect using the...
Hi,
I'm using SDK v15.3.0 which has s132 6.1.1 to program an nRF521832. I had a single custom service on my stack and that was working well. I added a second service and...
I'm Currently working on nRF52840. I am trying to change Name for Beacon received from one of the Beacon's Characteristic and storing it in Flash. Now for name I am changing...
Good afternoon,
I'm connecting my nrf52840 device to my laptop, and it only shows up when being put in bootloader mode. Is there any way to fix this? Thanks in advance.
I am using power profiler from my MAC pro, to test my 51822 DK. And I got following errors:
Error while setting up device 000000123456: No firmware defined for selected...
