I am using an nRF52840 USB dongle to sniff some Zigbee packets for a product I am developing. I am trying to use Wireshark to decode the messages shared. I followed the steps...
Hi,
I have set up a destination in the the NRF Cloud Message Routing Service
The destination has been verified and I can successfully send the test message from NRF Cloud...
Hi,
I was looking at integrating a speaker in my design and i have a class d amplifier that takes in an analog signal which i want to feed directly from the chip. I wondered...
Hello,
I am using SDK v2.9.1 for a Bl653 (NRF52833) and was trying to use the Nordic Academy Example for how to setup the SPI bus. The Nordic Academy example states we must...
I'm currently working on configuring the nPM1300 used in our custom board. In the product spec v1.2, it supports 2 USB compliant current limits, IBUS at 100mA and IBUS at...
Hi,
I am currently trying to enable the GPIO output interrupt functionality on my nPM1300ek with an STM32. However, I am unable to get it work correctly(I was only able...
Hi,
What is the lowest possible current consumption for nrf52840 dongle dev board with zigbee ?
I'm using this for development and i'm getting 20-30uA in idle. Is it possible...
Hi guys,
I plan to buy the development kit from Nordic but I had a couple of questions:
1)I know that in a previous question I posted I was told that I can use the development...
I bought the nRF511822 development Kit, not realising that it needs the nRFgo motherboard to supply power to it.So i have to make do with what I have. I am trying to power...
So this should be a trivially simple demo to run, but I'm obviously doing something wrong. When I build the sample application called "uart_example" in the PCA10000 folder...
Hi,
i want to build a BLE mesh via advertising. i asked some questions before about ibeacon and observer, how ever to clarify my question i have some additional questions...
Hello,
I have set nRF51822 Evaluation Kit. With its help, I would like to read the pulse of the heart rate monitor:
link text
I manage to connect to it using the...
Hello, I read an article on Nordic site about the Blend Micro:
*"The Blend and Blend Micro also natively support (with no extra wiring) all Nordic Semiconductor nRF8001...
Hi,
I have a few questions on how to receive data (from an iPhone app) as a a peripheral device on nrf8001 (with RedBearLab BLE shield).
Basically I am trying to receive...
Hi,
how do you use the jlink gdb server?
All i get is Target halted (PC = 0xFFFFFFFE),
gdb will obviously not show any helpful trace for that and continue doesn't work...
Dear Nordic guy,
I 'm developing LG product with nrf51822 chip.
I have some question.
Applcation SW timer use the rtc1 clock source.so,
When NRF_timer interrupt expired...
Hi, I'm attempting to use API 2.1.3 and am experiencing some weird issues with transmission intervals. When I use UpdateConnectionParameters to set a connection interval of...
Hi,
I want to upload a firmware using DFU mode.
If I use toolbox 1.8 app of android I can upload the new firm, but If I use toolbox on my iphone, when I push upload the...
Does the s110 stack allow retrying pairing procedure?
It looks like the stack (peripheral) always ends with disconnect upon invalid passkey.
We would like to explore the...
Dear Sir,
In SDK5.2.0 S310 HRM example, one nRF51422 act as BLE and ANT RX character.
Another nRF51422 with S210 software act as ANT TX character to send out command...
