Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi team,
My customer is using Thingy52 for some prototype and they output some data from sensors, 2 questions:
1. What does the form of the data means as "6Q10 fixpoint...
Hi there,
Is there any certifications required for the newly developed product that is using nrf SDK and nrf52832 SOC and can we use bluetooth logo in that product?
...
Hi
I am trying to connect my nRF52832 DK with Raspberry Pi via BLE. I am able to discover the board on Pi, when bluetooth is turned on. However, I get an error on Pi saying...
Hi ...
i want to change the device name dynamically, i read my questions related to it , still not working . Here , gap_param_init i have set the flag to change the device...
To the kind attention of Nordic support team,
I have got a
1. PCA10040 board, with ble secured bootloader installed
2. PCA10056 that I usually work with every day, these...
Hi,
I'm using direct advertising in order to connect to mobile devices which were already connected to my nrf device. After the first connection, I save the mobile address...
Could it possible to reduce INIT and ADVERISE times ?
What is normal startup time for nrf52832 init peripheral for advertising?
What is the minimum possible advertising...
In the OPS register description, as well as in the files modules/hal/nordic/nrfx/mdk/nrf5340_application.h and nrf5340_network.h the HFCLKAUDIOALWAYSRUN register is incorrectly...
Hi Guys,
I'm looking for some information on how to get data from the secure side to the non-secure side of the firmware. We are building an NB-IoT GPS tracker which is...
Hi,
Is it possible to change the security option of characteristic read or write?
For example , we initial the characteristic as JUST_WORK? Then change it to SEC_OPEN...
I have adapted the " nrf52-mpu-easydma-using-timers-and-drivers " project from Github that I saw referenced in another post and have successfully modified it to work with...
Hi, We are using the heart rate example for developing our firmware, where we plan to send data out every 15 mins. But when we try to increase the advertisement interval beyond...
Hello Nordic Team,
Currently i'm trying to join my custom HID (a joystick) with the ble_app_hrs_rscs_relay example (SDK 16) for a personal project which consist in: a nrf52832...
