Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello All,
Please share me the link where I can get complete explanation on software part for how to use following wakeup options as stated in datasheet
1]The detect signal...
Hi all,
I have 3 nRF52840 Bluetooth tags and I have used Segger Embedded Studio for programming the nRF52840 for the proximity application. Once I have programmed all the...
Hi,
We are seeing some strange stuff when trying to pass floating point values to a function. When we pass the parameter by value (meaning as an actual floating point number...
Hi!
I'm trying to communicate with modem through UART.
Power supply: Battery connected to VDDH
VDD_nRF: 1.8V
nRF52840 DK connected to modem devkit using wires (about...
I am using example code TWI_sensor. It is the same code i just switch ports and added couple of lines that would power up my sensor. After running it i can't even clk going...
Dear Community;
I am using this code provided by a Nordic engineer to make some HTTP request in order to use Telegram Bot API . It works fine but after 1-2 days working...
Hi,
I am in search of an SoC capable of processing data and having Bluetooth features. I have to use it in an automotive design and need to be compatible for the application...
Hi, I am having an issues when i run the command
west init -m https://github.com/NordicPlayground/fw-nrfconnect-nrf This is the response : I found a similar issue here but...
I'm trying to find documentation about the RADIO peripheral of the NRF51822 chip. In the NRF SDK file nrf51.h i can find all the registers like 'PCNF0' and 'CRCCNF' but there...
Trying to setup nRF Sniffer v2.1 for nRF52 Development Kit (PCA10040)
1) Wireshark does not see the Sniffer. When I run nrf_sniffer.bat, I get this:
C:\Program Files\Wireshark...
Hi,
I am now trying to reduce the total number of packets during the dfu process. After reading all the code about dfu in both app and bootloader, I find that in this process...
I am trying to install the pc-ble-driver onto my PC so that I can get the dll and lib files necessary to read/write from a nRF52840 Dongle programmatically. I am following...
Hello, we are using microchip bluetooth as uart tranpsarent and we have custom app in android to control it. In future we are going to do mesh application in android. But...
Hi
Using SDK for Mesh 4.0.0
I had a strange behaviour: Setting up a model with publication period 16s resulted to an interval of actually 10s. Multiples of 10s were working...
Two traces are attached performing the same function. A connection is made to a bonded device. The peripheral times out and the central tries to reconnect. with SDK 14/SD5...
