Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hi,
I am using nRF52840 and nRF52832.
1) I am seeing below statement in Product specification of nRF52840 under section “7.1 Pin assignments”. What does this mean...
Hi Nordic. I am using nrf mesh sdk v4.10 and an nrf52840.
I would like to report a potential bug regarding the Light LC server.
According to the mesh specification regarding...
Hello,
I have a strange Problem. I have a Central Application where the Central will get a TagID via Uart and if there is a adv. from this Tag the Central will connect to...
Hi Team,
We are using MBN52832 Murata module in our ongoing project.We need technical support from the team.
We need hardware integration (connection) support from the...
Every once in a while I am experiencing the soft device error NRF_FAULT_ID_SD_ASSERT.
In this post I saw that you may be able to provide some information on what is going...
Hello everyone,
I work with a custom board with the nRF52840 chip on it. We have pressure, humidity and temperature sensor and accelerometer sensor on the board. We need...
Hi,
We have a product that have a BLE capability (not by Nordic) and already have a mobile app that works with it.
I am developing now the FW for the upgraded version...
Hi devzone-team,
my application (custom board with nrf52840, sdk 16.0.098 ) uses 12 timers and it's organize in the 3 parts: uart, a pwm-bus ( proprietary) and ble-scan...
hi,
my application use boot and soft device.
Is possible with the application erase only the customer register in UICR ? (of course switch off the soft device)
This...
My company is using nrf52832 and our certification agent (we will apply for CE Red and FCC for our device) is wondering if the chip manufacturer is a SIG member, otherwise...
Hello I am new on KEİL and NRF52832,
I am trying to merge this custom service and Ble_app_gls example . I added custom services libraries to ble_app_gls example ,I added...
Hi,
I want to set a custom value to my Gatt characteristic value. I can do this by writing to the characteristic in my app or the NRF_connect application.
What I want...
Hi,
I am using sdk15.3 for a project, the uart works fine when programmed without bootloader, but just after add bootloader, the uart is not worked now, also the rtt log...
