Hi,
I'm using the nRF52833 to develop a BLE beacon and built a Bluetooth gateway for my application.
Application Requirements:
The beacon should advertise using...
Hello,
I want to perform some antenna measurements and compare the rf performance of my custom PCB with an nrf9160 SiP with the nrf9160 dk.
To perform some antenna measurements...
Hello - I have the exact same question as proposed in this thread - I am wondering if there has been any change in the 3 last years since it was posted.
In a nutshell, we...
Hi I want to build a multi role BLE device.
As a peripheral it shall stream ADC data with arounf 20 kbytes per second.
As Central it shall receive adv_nonconn_ind packets...
Hello everyone,
I have an nRF5340 microcontroller (NORA B106 module), and I want to connect a square wave signal to one of its pins to read its frequency or count the number...
Hi,
Hope you are doing well.
I would like to use eSIM on nRF9151-DK board and an eSIM has been assembled in the board. However, eSIM is not detected.
According to...
Dear Nordic Engineers
I developed a PWM function to drive the RGB LED. Then I found a problem, which is w hen I used a PWM signal of one channel to control the RED light...
Hi,
I am wondering what to do to fix the error I have been getting while trying to debug my project. I am using app_trace for logging. I would often get an error on the...
I have a custom PCB with nRF51822. I have copied the "QFAA QFN48 with internal LDO setup" schematic from Product Specification v3.1. However, I have not copied the PCB layout...
Hello,
I am using a custom PCB with ISP130301 BLE module based on nRF51822. The PCB layout for the module is designed based on the recommended PCB land pattern and solder...
Hello,
yesterday i ordered th nrf52 Development Kit an just had a look in the Errata infocenter.nordicsemi.com/index.jsp So if i get my Development Board, will all this...
Hi,
I've read posts showing programming the Beacon with nRF51-DK using the debug-out port. As the nRF52-DK is available right now, does anyone have any idea if I can use...
I'm using SDK 7.1, PCA10028 eval board, SD310 2.0.1, MCP 3.8.0.7
I need to check if notifications have been enabled by the central - if they have I then want to notify...
I wanted to test nrf51-ble-driver_linux_0.5.0 in the latest Ubuntu, but got this problem:
...
OSError: libboost_thread.so.1.54.0: cannot open shared object file: No such...
Is this even possible? I have a BLE connection with an interval of 7.5 ms. I've set up a radio notification with a distance of 2680us in order to be able to transmit 4 BLE...
Hi,
I want to know how sd_ble_gap_authenticate api works.After executing this api, what are the events invoked at peripheral end. Is there any event that blocks CPU or...
We are designing product based on nrf2401A
The problem that we encountered was that the nrf2401A forgeted configuration data, was it possible ?
we use our product in highly...
Hi,
I am using the nrf51822 in an intermittent high-current application where if the battery is close to dead, will sometimes cause the chip to reset because the voltage...
I am using SDK 8.1.0 and Eclipse on a Mac. I am having difficulty flashing my app that uses the nRF51 sdk onto nRF51. I am using JLink
I assume I need to flash two things...
Hi nrf51 developers,
I'm developing multiprotocol application by combining BLE and a proprietary protocol. I'm using concurrent multiprotocol timeslots API. Started with...
