Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hello all
I'm struggling with link errors, "undefined referencce atan2" as well as all math library.
I still dont know why it is occurred these errors.
I configured the...
Hi,
I'm trying to move my code from Red Bear BLE shield with Arduino to nRF51 dongle.
Is there any possible method?
(ex. share the same library or SDK helping)
I just read the S13x migration guide .. have some work to do :(. I'll have to read it a few more times to get my head around the bandwidth configuration but it looks super...
Hello, I started with NRF24L01 + Arduino and that works fine for me. Then I saw the nrf24LE1 and I thought that would be smaller and cheaper. I ordered the NRF24LE1 development...
Hello Everyone,
I was taking a look at the PCB in Ditto . It uses an nRF51822 and supports firmware updates from their app which means they put a bootloader on it.
I've...
hello guys,
I'm working in a project & I'm debugging using nrf15822a development kit, I want to implement the DFU & security feature to have a secured link and to be able...
Hi guys..
I try to figure out how to connect nrf 51df , raspberry pi (ble enabled router), COAP client which is on the external network. Trying to figure out it, I found...
I noticed the following compile time issue in the SDK - both 10 and 11:
The file ./examples/ble_central/ble_app_hrs_c/main.c
needs:
#include "app_uart.h"
For...
Hi,
Could anyone give some advice how can I let 51822 works in RFID mode.
Can RFID work together with BLE? Or is there anoter HAL support like Softdevice? Where can...
Interrupt_Sleep.txt
Currently, I'm trying to use external interrupt that generated by ADXL345 to wake up the nrf51822 after sleep but not working as i want. Kindly check...
I'm had develloped some software and tested it on the nRF51-DK.
After that I made my own PCB design where only the nRF51422 is replaced by a nRF51822.
When I flash both...
