Hi,
I use UART bootloader SDK example(dfu_dual_bank_hci) to do update firmware on EK PCA10001 board,it can work ok.But i changed the HCI_SLIP_UART_RX_PIN_NUMBER and HCI_SLIP_UART_TX_PIN_NUMBER...
Hi. I have been trying get a notification through ANCS.
I have created an app which is made by modifying ble_app_ancs sample.
It works basically but there is one problem...
Hello,
I'm using the nrf51422 with 210 softdevice.
I'm trying to figure out a way for the receiving slave device to go to sleep when away from the master, but to wake...
To be able to upgrade FW through UART, a bootloader for nrf51822 is required in my project. I have tried out the example bootloader in SDK. But this example is using softdevice...
I followed the forum posts and nan-29 to get eclipse 4.3.2 to successfully connect to JLinkGDBServer via a Segger J-Link EDU on Ubuntu Linux.
I can start the GDB server...
I'm using Softedevice 6.0.0 and SDK 5.2. and Keil 4.7.
I Modified bootloader project so it compiles with both ble and hci transports. Currently I use button_0 and button_1...
I am working on the proj that needed 2 MCU and nrf51822 work as slave.
I would like to know any ref on how to firmware upgrade on board without external tool?
Hello?
This is simple inquiry about a method to update some comments regarding of the ticket pending due to reviewing by Moderators after open it.
When I found a solution...
Hi
I've played around a couple of hours with the nRF52840 Dongle and tried to understand what can be flashed to the nRF52840 dongle and what can't. This issue is not about...
Hello Nordic,
Currently we are working on a project based on nrf51822. Now we are planning to upgrade to nrf52832. so I can run the same ble4.2 based code on ble5 chip ...
Hi,
I am developing device using zigbee[nRF52940].
Many end devices send some information(less than 100 bytes) to coordinator directly or via router.
I cannot find proper...
Hi there,
Background:
I have set-up a gap peripheral device (nRF52832 / SDK 15.0.0) with 1 service with 2 characteristics, each having its own custom 128 bit UUID. i can...
Hi.
Im trying to follow the tutorial to open a Keil Project in Segger Embedded Studio but i get this error when i am trying to build
.
I guess it is somthing with the...
I want to change the pipe linking the PTX and PRX dynamically. The command to do this is sent from the PRX in the data payload of an ACK.
I can successfully change the PTX...
Hi guys,
I am using nrf52840 with sdk15.2 and have been experiencing some strange issue. After mobile phone connection to the device i lost 1 byte in advertisement or saying...
Hello,
Is this possible to use different speeds at same device for different roles.
I have device that is working in peripheral role for other device and need to send...
Hello, is the logging module thread-safe? Do I have to use a mutex when logging from a lot of tasks when using FreeRTOS or is the logging module thread-safe and I do not have...
Hi, the tool nrf9160_mdm_dfu mentions in its Readme that three files are needed for DFU to work:
"To use this tool, you need to have the following three files: ZZzzZZzz...
Hi,
I am beginner in nordic development. I will be using using FreeRTOS with nordic ( if that matters).
Requirement: I need to store logs in internal file system.
Device...
Hello,
I'm doing some tests with TX power on my development kit and I would like to increase my transmission power in openthread FTD to +8 dbm.
I had read this thread...
