We're looking for a Nordic nRF51822 based low profile/small USB dongle that we can use for our iBeacon software.
It would need to come complete with casing and the ability...
Hi all,
i want to establish connection between two threads in cmsis-rtos, can i use
1) semaphore to do this?
2)message queue should be used or any other ipcs can be...
Hi,
I have two CPU in our product. (STM32F2 and Nordic nrf51422).
I use serialization function to link those two CPU(refer to ble_s110_serialization sample)
But I find...
Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
Do you agree that the following AI response is accurate? If so, I understand it to mean that I need 3 capacitors: one 68pF in series with each NFC trace and one 430pF in parallel...
Hello everyone,
We are currently working on a project in which we plan to use the nPM2100 + NRF powered by two AAA Li/FeS2 batteries.
We would like to use the nPM2100...
Using NCS 2.9.0, on a custom nrf5340/nrf7002 board.
When connecting using WPA2-PSK to a Cisco AP, it seems the wpa supplicant adds some Cisco specific IEs to the association...
Hello I am looking for some guidance. I have not found a clear answer in the documentation, but should a nRF5340 host used with nRF7002 have an external HFXO? We only use...
Hello Nordic Team,
I am working on OTA functionality using nRF Connect SDK 2.9.0 on the nRF52833 controller.
Earlier, my application size was around 320 KB, and I reduced...
Good afternoon,
My device communicates using MQTT a few times a day. After many connections I noticed that communications stopped. Every connection attempt would fail with...
Hello all,
I need to sniff some packets to fix an BLE issue, but I can't find the hex files to program my nRF52840 Dongle. The links provided in the documentation and website...
Hi, I tried to start toolchain manager on my main computer and its not working anymore. I tried to delete all nrf related folders, deleted all apps including nrf connect deskop...
Here is a focused support ticket description for your actual issue:
Device: nRF5340 DK ( nrf5340dk_nrf5340_cpuapp ) SDK Version: nRF Connect SDK v2.5.1 Modem: Quectel...
Hello, I'm working with Power Profiler Kit II and i see that we can use a digital port. I would like to know what the electrical levels for a valid High and Low. I can't find...
Hello, Currently I am working with the nrf connect SDK version 2.8.0 with an nrf5340 SoC. There is no external flash memory. I am trying to build a bootloader with the serial...
I have created a Zephyr Snippet (derived from the cdc-acm-console sample).
I am unable to select it in the Build Configuration. It is listed in the dropbox where the sample...
Hi,
I previously had access to the nRF54L15 Early Access SDK and toolchain, and my local EA workspace has been lost. I need to rebuild my development environment for a project...
Hello,
I am currently implementing a Central device using the nRF52810 as part of a Gateway board.
I intend to connect the antenna via a U.FL connector . My current design...
