Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi Tech support:
I am using the latest Desktop nRF Connect(Windows version) tool. And I want to use it to connect to my nRF52 DK board and setup up an advertising setup...
Hello,
for our application i need to periodically enable and disable the openthread stack on the nRF52840 chip.
For testing purposes i've modified the Thread CLI example...
Hi,
In my application i am trying out to transfer data in Long range BLE_GAP_PHY_CODED mode , i have set my peripheral has to advertise in PHY coded mode below is the advertising...
Hello,
We are using nrf52832 in our development, we recently got the otii arc to measure the power consumption of our device.
During sleep mode we notice a huge spikes...
This should not be very hard (beginners question), I want to convert an array of characters to an integer, I added string.h but it is not working with the function strtoi...
Hello
Now we are testing the third version of nRF52832 nrf52833 nrf52840 ic
I learned that there is a feature to lock and unlock the debug port of the device, but I use...
Hi Nordic,
I am using nrf Connected SDK 1.7 on windows 10, coding with nrf connect extension for vscode.
I created a custom board from nrf5340 SoC and added a node as...
Hi,
I have made a manual installation of the nRF Connect SDK in order to develop nRF5340 applications on my Ubuntu PC. I have tried, to the best of my ability, to follow...
I've tried sending ASCII "Hello world" over SPI with various data rates. Somehow clock signal given by SPI is not continuous. This discontinuouty differs with clock frequency...
Hi everyone,
I want to integrate the Queue module into my firmware. I found three functions for writting elements in the queue
1. nrf_queue_push
2. nrf_queue_in
3...
Hello,
I am migrating my project from GPS driver to GNSS interface. I am facing a few problems when I am using GNSS interface.
1. GPS driver can generate simulation data...
Hello,
I am new to the NRF World and try to explore some Ble examples. Unfortunately I can't get the BLE_Blinky Example working. The Flashing works without problems, and...
Hello,
I developed a script which has a 40Hz timer which repeatedly starts the NRF52840's SAADC in continuous mode (with a 40kHz rate) which is supposed to fill a revolving...
