Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
HI,
I compiled MQTT sample, and always got :
ERROR: mqtt_connect -60
timeout error.
It seems that it takes about 2 minutes to get LTE link connected:
LTE Link Connected...
https://github.com/takafuminaka/nRF52832/blob/master/i2s_ws2812b_demostration_planB/i2s_ws2812b_drive/i2s_ws2812b_drive.c
I read the documentation, but didn't really grasp...
I'm attempting to use the UDP with PSM sample provided at this Nordic nrf9160 samples branch . I haven't changed anything within the sample itself. I've been using it to demonstrate...
Installed Segger Studio v4.12, nRF5 SDK(latest version), J-link, all under same catalog but into their own respective catalogs.
First, if I open blinky catalog and choose...
I am receiving "ERROR 4097 [Unknown error code]" returned upon calling nrf_sdh_enable_request. I found that ERROR 4097 corresponds to NRF_ERROR_SVC_HANDLER_MISSING from some...
I have the following code. I need to add a second counter attached to the spi_end_event. The first counter "count_task" is working, but can you tell me how to get "count_task2...
Hello all,
we have currently a problem with writing to a custom chracteristics in nRF52832 with softdevice S132. When the characteristic is written, we get responses only...
Hello, i am making a "simple" project, the goal being changing the duty cycle of the pwm depending on saadc sample value. My goal is to sample audio, process it ( low pass...
Hi,
I am implementing a keyboard with nrf52832 + s132 from sdk 15.3.0. Recently noticed that when trying to pair the device with a Windows 10 laptop and it keeps saying...
I'm using the CMake scripts in the Nordic mesh SDK to build my project, as the project uses CMake libraries. I want to determine the RAM usage of my application. I saw this...
Using J-link programmer, I try to figure out how to set some kind of security bit to avoid 3rd party reading code from flash.
If you could please return me a helpful link...
Using NRF51802 power-on reset failed, I have to manually reset each time, the program will start running.
The following are the information that may be used.
1.Schematic...
Hello.
In last couple of days I've been trying to figure out how the whole SDK is structured and how to start developing essential applications using the Segger Embedded...
Hi , so I witnessed this weird phenomenon:
When I use the simple On-Off-Model (as a base for a custom vendor model) in the switch application, the handle_set function in...
