Hi
I am looking at section 9.1 of the S110 Softdevice Specification v1.3A and the release notes for 7.0.0-2.alpha where I see that an application now starts at 0x15000...
Hi
S110 v7.0.0-2.alpha got released today.
In the release notes it says...
[b]The SoftDevice can now be configured to forward interrupts to one of several applications...
Hi,
I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...
Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
One of my nrf52840 DK cards wont detect as jlink, nor bootloader drive anymore. But I can still program it using a Segger jtag programmer and P18 port. Running Windows...
Hi.
My NCS version is 1.6.0. When trying to compile ./zephyr/samples/subsys/nvs for nrf9160_dk, I'm getting the following error:
Do I need to provide some custom overlay...
Hello, I recently bought the Laird BL654 DK which is based on the nRF52840. ( www.lairdconnect.com/bl654-ble-modules-and-development-kits) . I was interested in running the...
Hi. We are using the nRF52 sdk v15.2 with S132 v6.1.0 on a nRF52832. Sometimes, when connecting, we get a crash with
identifier 0x1
program counter 0x3FDA
fault information...
Hello,
I'm going to send data from a distance of 100-150m using Bluetooth long range communication.
When I looked up some examples of this, I saw that two development...
Hello!
Running Windows 10, nRF Connect for Desktop v3.7.0, Bluetooth Low Energy v2.5.2.
Have the following section added to the uuid_definitions.json:
The problem...
I am sending data over air from an XBee in transparent mode to an nRF52840 dongle as ZC.
The data is going over the air from the source and destination addresses using a...
Current status. Bond is required to perform FW updates while in OTA mode.
What we want: No Bond is required for FW update in OTA mode, FW files can be uploaded unilaterally...
Hi,
I have questions about the connections between the nRF5340 and the FEM nRF21540.
The nRF5340 has these components:
And the nRF21540 has this component:
I wonder...
Hi everyone,
I am currently reading the nRF53 Series product specification from the info center for evaluation purposes. During reading and looking at the application...
Hello.
Please forgive me for a real beginners question but I would like to understand the relation between the menu configurations in SES and the different configuration...
During a FW update, it failed for some reason and then I couldn't get anything to work. I can't come back from OTA mode. Reset does not work either.
According to the log...
I just found out there is no SPI slave support for SPI3 on NRF52840, but the memory map shows a SPI master for SPI3 though. Is it possible to enable SPI slave on SPI3? We...
