Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi ,
nRF52810, SDK : 15.2.0, using SES,
I have two questions;
I am trying to add DEVICE NAME to the advertising beacon, in the ble_app_beacon example and following this...
HI,
I succeeded in the test.:SPIM0 SPIM1 SPIM2.
I failed the test SPIM3.
Please help me configure SPIM3 init.
1. The SDK: sdk17.0.2
2. Example: D: \ Project \ nRF5_SDK_17...
I tried to use printf() to get the data from SPI buffers. It runs OK in the peripheral/spi example. But when I moved it to the ble_app_uart, the program stalled at printf...
Hi,
We are looking to upgrade our connect SDK version to 1.7.1 (from 1.5.1) but at the moment there are a few breaking issues for us that will prevent us from doing so....
Hi All,
I have a question that i remark this code run different mode have different results
in Release mode => build success,the project can run
in Debug mode => the...
Hello.
I have couple of questions for hardware parts location on pcb with nRF9160.
Q1.
I'd like to ask a better location for eSIM(MFF2) related nRF9150.
This...
I'm trying to add a second element to (light_switch\server) (SDK_for_Mesh_v5.0.0). I've already have a look at this post , it gives an idea but I found that it's not applicable...
In an effort to fix Toolchain problems setting up nRF Connect, I uninstalled Python and tried reinstalling via choco install python as per the "Installing Manually" instructions...
Hi,
Please fix this bug: The DK device is no longer found after following the following procedure
Problem operation process emerges
windows:
DK:PCA10090 0.9...
Hello,
I started my prototyping with the 52840DK and the SD Card was working fine. However, with the 5340 dev kit, I cannot get the SPI to work and access the SD Card properly...
Hi,
I connected my nRF52840 dongle to the laptop, it was detected with a red LED glowing on and off. Later I installed the nRF Connect software and installed the Power...
In our nRF52832 application, we have an external 32.768KHz crystal as the nRF52832 low frequency clock source. We also have a 32.768KHz oscillator on the PCB that is used...
Hello,
There seems to be a bug with scanning for many Bluetooth advertisements while simultaneously sending data over uart in Nrf sdk v17.
I have tried to work around...
