Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi I'm a bit new to programing with nordic.
I'm trying to use the nrf_gfx_background_set function to display an image on an epaper panel. I've already written code that...
Hello, Nordic.
I am developing a project that is based on interactive services that exchange data through BLE connections.
Everything is good except for service discovery...
I may be stupid, but I cannot find any indication of which device is currently handled by the nrf9160 DK probe in the nRF Connect Programmer or Segger IDE.
As far as I can...
Hello, i have a question about keepout area under antenna trace in multilayer pcb. I have a 4-layer pcb, but substrate height between top layer and first mid layer isn't enough...
I've been burning the certificate to nrf9160 with commands,but it doesn't work, mqtt connect will be disconnected by server when nrf9160 connect to the server.how to solvel...
Some time ago, I reported an "issue" to pc-ble-driver team to ask them to make the dongle LED shine when it's ON (else, there is no way to know if it's correctly programmed...
Hello,
My setup is the following: Up to 4 peripherals (nrf52832) and the central device is a PC running Windows 10. To make it simpler, I'm just using 2 peripherals at the...
Hello, Team.
Now I'm using four nRF52840 DK boards, and testing the 'Light switch' example.
I want to monitor the mesh system what nRF52840 DK are making.
Because...
Hi
To develop aoa / aod projects, I have bought nRF5340 PDK. I want to know whether there are aoa aod related demo projects in SDK of nRF5340. And how can I get aoa / aod...
Hi,
Iam on SDK 15.2 would like to have a Characteristic value as an array of floats.
I have done it but it prints it like some bytes on the Nrf Connect app. So i have...
Hi,
I am working on changing my GET request to a POST request and am failing at the connect() function, which makes me think I have the wrong header. There seem to be multiple...
Hi,
I can use the nrf connect programmer to burn after merging the softdevice and the application.
but i can not use the nrf connect programmer to burn after merging the...
Dear Community;
Is it possible to flash a .hex file to an nRF 9160 DK using Bluetooth? Something similar to nRF programmer but using Bluetooth instead of USB OTG cable...
Hello,
I am using nRF52840, S140 v7.0.1.
Till last week I was able to compile and load on nRF Dev Kit. But today suddenly it stopped working. I am getting below pop...
