Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
Hello
I have an application running which boots up fine.
I've written a bootloader which boots up first, and then jumps into the application including softdevice.
So...
I am trying to implement a TCP server with TLS support. I have the following confusion-
Do we need to use mbedTLS API explicitly or is it internally handled by a zephyr...
Hi,
I am developing a simple application where I read some data from a sensor, and publish the data with MQTT. I want to use PSM to conserve battery life, and I am able...
Hello,
I am using a nrf5340DK to test the BLE Central sample of Zephyr.
As a BLE peripheral I am using a nrf52840 dongle. I have it configured via nrfconnect SDK - Bluetooth...
Hello,
I try to modify the lpcomp example from the Nordic SDK to trigger the sampling of the lpcomp manually. I have added the following code:
I use AIn3 (GPIO 5) as...
Hello,
I'm using Zephyr SDK. I have got BLE characteristic (my device is a peripheral) with following settings:
After successful write operation, I want to reply with...
Hi,
I'm trying to build the peripheral_lbs sample app for the nRF5340 using VS Code and I cannot get past the build configuration stage. Any assistance would be appreciated...
Hi.
I´m trying to install the application asset_tracker_v2 on my nRF9160DK ver 0.9.0 board.
I´m using VS code and during the build i got errors.
"too few arguments in...
Is there any good tutorial about the Android-BLE-Library Nordic library ?
I have only found the examples, but you need to dig in the code to learn how to use.
Greetings,
What are the settings to allow an nRF52811 to use CODED PHY with the NCS peripheral_hr_coded sample?
NCS v1.7.0
board = ubx_bmd360eval_nrf52811 (effectively...
Hi,
nordic tearm,im use nrf52840 develop a ble hid keyboard,my description of report like this :
my send api like this:
my consumer key like volume add and reduce...
Hello,
In the document about Release assistance indication %RAI. It says
In addition to using the %RAI command, the application must tell when the data connection is...
