hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
Hi
I am writing an app to utilise the new LESC feature using Diffie Hellman related pairing. I am testing the app against the Nordic provided ble_app_multirole_lesc. I...
with SDK 10 I found 2 SPI libraries, spi_w5_master and nrf_driv_spi . I hesitate between them.
what' the difference between them? and what should I use when I'm using app_timer...
I saw this tutorial:
nRF51 current consumption guide
It's specifically directed to the nRF51, but I guess the principles of Tuning Advertising parameters must be general...
i'm looking to use only one timer for two independent activities:
battery service (as in Nordic examples) and
a routine to detect a certain button press pattern ...
Hi everybody.
I am makeing a custom circuit for nrf51822 CEAA. This circuit supports ANCS and DFU (nrf sdk 9.0.0). I use only external high frequency (16MHz) oscillator...
Forgive me if there is an obvious answer to this; thanks for your patience.
I'm a long time developer but new to the area of BT in general. After a day or so starting with...
Rudimentary question about DFU; thanks for your patience.
I'm developing an app for a "headless" (no buttons, no led's) ble application which will have a companion mobile...
I am trying to get the pstorage module to work with our application and FreeRTOS. At the moment I keep crashing on port_cmsis::prvTaskExitError().
The pstorage documentation...
Hi,
Nordic Community and Developers,
I am trying to measure current on my custom Development board.....But I found out that it is consuming too much current on the chip...
Hello,
I am writing here because I am trying to change some concrete values from a .hex file in order to vary some BLE and other values. I need this because I need to generate...
Hi,
I am trying to compile & run ANSC example under SDK8 in a PCA10001 board. I have programmed the SoftDevice using nRF Go Studio.
Here is the example,
nRF51_SDK_8.0...
