I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
Hi Dev team,
I have an application working on the Thingy91 that sends the data of the sensors through MQTT to our server. I was interested in knowing the data usage of the...
Hi All!
I'd like to ask if anybody succeeded running zephyr without optimizations?
For ex. i have a following code:
Now i have following problems: 1) If i set...
Hi,
We got carrier frequency tolerance failure in a certification test.
The max deviation should be under 20ppm, but the result is above 30.
We used DTM example...
I'm working in a project where I have to use produce a PWM signal which actively drives the pin low for 0, and disconnects the pin for 1. The PWM is generated by an in house...
Dear Members,
For checking my LF 32KHz crystal is working,
XL2 is the output of the crystal ? or vise versa ?
So XL2 to the scope and the other probe to the ground...
Greetings,
I'm trying to develop a project on the nRF5340 DK where I collect measurement data from an I2C sensor (LPS27HHW) before sending the data via bluetooth. My firts...
Hello i'm trying to run a sample from my projects but each time i'm getting the CMake error i tried changing project and running from another directory but the problem still...
Hello,
we try to add DTLS to the CoAP client example . We have problems with the DTLS connection. The handshake with PSK works. The first CON or NON query works also without...
Hi! I developed a locator and beacon pcb boards for AoA direction finding using the NRF52811 chip. The locator has 4 patch antennas and the SKY13575-639LF external antenna...
Dear Members,
I want to use MAX17048 and getting thiis message :
<error> app: ERROR 33281 [NRF_ERROR_DRV_TWI_ERR_ANACK] at ..\..\..\MAX17048.c:71
void MAX17048_init_i2c...
I have found an issue with ESB/Nordic radio where it will receive a packet on the wrong pipe. I think the issue occurs when the prefix array set to the PREFIX registers contains...
While testing our custom Hardware with the nRF52840 in a climate chamber in the -40°C to +85°C range i noticed that the value read from the internal temperature sensor was...
Hello,
let me explain my problem as below.
after doing pairing between nrf52832 and phone(android app). phone is central (including scan behavior)...
after success...
Hi,
I'm using SLM app (on nRF9160 module) and I want to find a way to send a data (any data) to a server.
Can someone help to provide an AT commands sequence for that...
