But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
i have a trivially simple "bare-metal" (register-level) test case in which i setup GRTC as follows:
MODE.SYSCOUNTEREN = 1 TASKS.START = 1 TIMEOUT = 2
i also have the LFXTAL...
On a nrf5340/nrf7002 custom board, using NCS 2.9.0, I am trying to get a reliable https connection to different backend servers.
I'm having trouble with the TLS handshake...
I recently flashed a new application onto devices that has prevented any new application images from being swapped into the primary slot. Any new images are uploaded to the...
Hello,
I got the https://github.com/nrfconnect/sdk-edge-ai/tree/main/applications/ww_kws application running on the nRF54LM20 DK with the Axon NPU and it can correctly detect...
I found that CoAP requests unexpectedly block GPS positioning. So, the solution is to add a synchronization semaphore between them. I stopped the CoAP request while waiting...
Hi Team,
I am planning to implement a secure boot mechanism on the nRF5340 for one of our products and would like to ensure the design is robust, scalable, and production...
Hi
I am using nRF54L15DK, with SDK v3.2.2.
I want to implement an event log, persistent in Flash.
Initially I thought of using FCB, but I am running in to issues with...
Hi
I have custom nrf5340 based product, with an NFC interface for card emulation. I have managed to get this to work in raw APDU mode in NCS 2.9.0 (with selected cherry...
Symptoms
A GPIOTE event channel is configured to detect a rising edge on a GPIO input. Via PPI, the event drives a GPIO output low within a few hundred nanoseconds. The...
Hello all, I am following up on a related issue regarding mcuboots partitioning and image validation. ( link to previous MCUBoot QA forum ). I have devices out in the field...
NPM1100 outputs VOUTB (2.1V) to power the NRF52832. Programming is performed via J-Link with an external 3.3V power supply. However, this causes a short circuit between VSYS...
Hi,
I’m working with the Raytac BC833M module (nRF52833) and programming it via nrfjprog in a batch script.
I need to:
Program my application firmware
Configure...
I have an interrupt handler that sets a flag some of the time, and then runs other code in main whenever that flag is set. The code looks roughly like this:
I have debugged...
