After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I measure the quiescent current of Thingy:91X (v1.0.0) with enabled BLE connectivity bridge.
To my surprise, this seems to be significant larger than that of a Thingy:91...
Hi,
I have following problem:
I try to synchronize specific event let's say every three seconds. My simple test is just looping date_time_now() and taking modulus out...
I am attempting to create an SPI communication to an ancillary circuit through an intermediary board and the nRF52840 USB dongle. If I start with the zephyr sample spi_flash...
Hi, I am starting from the following example: "Bluetooth Low Energy UART service sample", sdk version v2.6.0 I am trying to add a custom board (using VSCode NRF CONNECT extension...
ncs v2.9.0
peripheral_uart (nRF52840) modified code
central_uart (nRF52832) unmodified code
using power monitor for current consumption
When I send the packet from...
I want to update some data stored in UICR CUSTOMER area on an nrf52832.
Code to do this works fine, as long as the areas are already erased (0xFFFFFFFF).
However, if they...
Hi,
I'm doing a test with a test harness. An error occurs in test case TC-CNET-4.16. I would like to know how to solve this problem.
environment
・TH raspberry pi 4 Version...
Hello everyone,
I am currently facing the issue that migrating to NCS 2.9.0 is not possible as I get the following compile error:
Someone else had the same issue: Unfortunately...
Hello,
This morning I thought I would investigate the current consumption of some of the examples in the nRF connect SDK Fundamentals using the nRF9151DK and the PPK II...
Hi there,
Can you please help me with setup Platform independent driver from ST with Zephyr?
STMicroelectronics/lis2dh12-pid: lis2dh12 platform independent driver based...
