Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I'm using the LTE Sensor Gateway sample (NCS 1.7) to transfer data from a BLE sensor to the nRF9160DK up to NRF Cloud. To get low power operation, I've been able to use the...
I've been working on firmware updating devices from Microsoft Azure, and when pushing new firmware update to devices (NRF9160), some of the devices has failed downloading...
Hi to all, I'm developing a new device that should be a multiprotocol: Zigbee (as coordinator) and BLE peripheral (nus).
I use the nrf5_sdk_for_thread_and_zigbee_V4...
Hi Everyone,
I'm working on "Thread_Zigbee_v4.1.0\examples\zigbee\light_control".
I need configuration as above title.
But I relize that "zb_set_pan_id(0x1234)", "nrf_802154_short_address_set...
I am trying to use the DK Dashboard with the Serial LTE Modem Software.
The connection to the Cloud works in principle but I only can see the terminal card when connected...
Hello,
Currently I am experiencing some problem getting the NUS to send a TX notification of more than 20 bytes to the central (which is an old custom android application...
Hello,
I am offloading sockets in config. I instantiate a socket, set the send/recv timeouts, and then call connect(). It's returning a 95 which is EOPNOTSUPP. I was able...
Hi,
I'm investigating firmware image signing on the nrf9160 using MCUBoot and the nRF Connect SDK v17. I have configured
and it seems to work via `west build -b nrf9160dk_nrf9160ns...
Due to parts shortages, we are having to scramble to find compatible hardware for our project. I have sourced some nRF5340 modules but need to know if Gazell is supported...
Hi!!
I am facing an issue wherein more than one device is acquiring the leader role in a same thread network.
In my setup, I have a total of 4 devices. Three of them are...
Dear Team,
I have to use many number of pages to store data in flash memory in nrf52840 , but I am confuse that what will be start address and end address in flash_fstorage...
Hello Team,
I am facing segmentation fault while reading the OTP memory using pointer in my code. To write the OTP value I have used below command which was successful and...
Hi,
I received the nRF9160DK yesterday, and used the AT Client to get talking to the modem and connecting to a network. In VS Code I built an application from sample ...
