Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
I'm reading the SDK15.2 documentation coming from SDK 11. I've noticed the nrf_pwr_mgmt module, but I haven't seen it utilized by any of the examples. When should this module...
I implement basic Thermostat Zigbee device on top of FreeRTOS v10.0.0 with nRF Thread and Zigbee SDK in version v3.0.0 When there is no network to connect then after some...
I am working long nrf52840 and trying to implement long range in my project. There were examples in SDK 15.2.0 but i couldn't find any example or post which is related to...
Hey,
I'm using the nRF52840 dongle with SDK15.3. Am trying to make it a central device that is configured as a HID mouse when plugged. So I'm combining both multilink_central...
Hello everyone,
I got an issue with the custom board nRF52832 ( Raytac BLE module ) as I only achieve very short distance between the BLE device and Android app without...
Hi,Master:
When I use the QSPI library to communicate with flash, everything works fine. After a complete read and write, nrfx_qspi_uninit() is called to reduce power consumption...
Hi i am using nrf52832 development board as central which scans for peripheral devices.
how to get peripheral device service UUID(128 bit) completely before connection?...
Hi there,
About radio packet config, would someone please help?
1. Meaning of the LENGTH filed in packet structure. Is it size of payload or of the whole packet? ...
Hello, In a product already in the hands of the users we started getting some issues when connecting to Android Devices
Using the nRF Connect Android Application whenever...
Hi, I have been working with my nrf51 DK for a while now without problems. When I first connected the board to the computer today, the ld5 led was blinking very quickly, and...
hi
i have a question. I'm working on a type of beacon system and need to advertising repeatedly unique beacon in less than 100 ms advertise interval that limited on non...
Good day!
In Light Switch example I made some changes to have GPIOTE events, instead of Simple HAL.
Now, when I try to publish message, debugger shows error in bearer_event_in_correct_irq_priority...
