Please,
It seems that "Flow Control" signal is not available on nRF24AP2-USB.
EVENT_TRANSFER_TX_START event message appears only one time after the first data packets...
I am looking for cheapest (up to few hundred USD) and simplest Arduino basic solution to track real-time RFID tags distance (also direction if possible) without additional...
Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
I have two nRF52840DK boards that I was working with recently.
PCA10056 3.0.2 2024.33
I flashed one board with a BLE peripheral device code from the nRF connect sample...
Hello,
I'm using dmic module for sampling audio data from microphone. Recently I updated NCS to 3.2.2 and I started observing the following log: "Failed to allocate buffer...
After an update recently with the nRF Connect for VSCode Extension, it's been unable to find where my nRF Connect SDK is located when choosing a build configuration. It used...
Hi,
We are migrating from NRF52840 to NRF54L15 (QFN48).
I am using nrf54l15-qfaa-reference-layout-0_8 as reference but really struggle to understand some design choices...
Environment:
Board: nRF54L15DK ( nrf54l15dk/nrf54l15/ cpuapp )
NCS Version: v3.1.0
Zephyr OS: v3.7.99 (NCS fork) NOTE: I am building this over peripheral uart example...
Hi,
I am developing with NCS 3.0. In my application, I need to use MD5 to calculate a signature. Following Nordic AI's guidance, I enabled CONFIG_PSA_WANT_ALG_MD5=y in prj...
Hi,
I have got nRF54LM20-DK with the nRF7002-EBII add-on. I would like to know is there any recommended camera add-on for this hardware to develop vision based AI solutions...
Hi,
I'm developing a custom board based on nRF9151 (similar to Thingy:91X) and trying to connect to nRF Cloud for location services (A-GNSS, Wi-Fi location, Cellular...
Hi,
I'm working on a project using the Thingy91x for prototyping. I'm using A-GNSS from nRF Cloud and although this is working, I'm not sure of the correct order of commands...
Dear support team,
I'm using:
nrf9151
nRF Connect SDK v3.2.3
I'm currently working on a project where I need to use MQTT and CoAP simultaneously, it works for...
Hi,
I'm referring to this post below
Based on the response above, it looks like IAR + NCS SDK is not supported by Nordic . Is that the official response from Nordic...
